Jump to content
SAU Community

Recommended Posts

Spotted a white R34 GTR M-Spec in Sydney somewhere (I don't go to Syd much if you can't tell). Had a very yellow rear bar.

I was in my mates green magna

Spotted a very nice R32 GTR (i forget plates) in WSID carpark

Spotted more R32's in the carpark.

Spotted a few series 1 R33's running at WSID

Spotted NE-33-XT at WSID

Also spotted TIM in the MX-5 running a few times, and ONN-20S

Spotted a white R34 GTR M-Spec in Sydney somewhere (I don't go to Syd much if you can't tell). Had a very yellow rear bar.

I was in my mates green magna

Spotted a very nice R32 GTR (i forget plates) in WSID carpark

Spotted more R32's in the carpark.

Spotted a few series 1 R33's running at WSID

Spotted NE-33-XT at WSID

Also spotted TIM in the MX-5 running a few times, and ONN-20S

perhaps one was me :D dark blue 32 gtr

LOL spotted that V8HNTR at liverpool KKs too.

V8HNTR is always across the road from my place in kellyville....

i wish i was lucky enough to get spotted..anyone seen a dark blue r32 4 door with red plates NG-0387 in the hills area? Cos thats me!

Edited by royalt
:P that hurt marsss

Dude... we're in the same boat here... so to speak...

I haven't been spotted in yonks... oh except for the other night..... and last week.... i found that "driving" my car gets results..

anyhoo.. spotted a white 34 in the airport tunnel today with Mine's stickers on it.. not sure if it was a gtr although the plates were GTR something something..

Dude... we're in the same boat here... so to speak...

I haven't been spotted in yonks... oh except for the other night..... and last week.... i found that "driving" my car gets results..

anyhoo.. spotted a white 34 in the airport tunnel today with Mine's stickers on it.. not sure if it was a gtr although the plates were GTR something something..

hahaha... you prick.

I'm sure I spotted Liz the other day, in her sexy little red thing :)

oioioi! with comments like that, people are gonna start talking!!! lol

yeah it was me, I couldn't see through the rear window clearly enough to notice it was you!!! :P

No-one spots me either, i see heaps of Skylines on the way to work and back and post it but they must not be part of SAU forum or they just too lazy!!!! =( havent been spotted once in the 2months ive owned the car!!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
    • Thanks for the replies everyone. Definitely a coolant push. Oil catch can is empty and always has been. As the engine is out now I'll be having a good look over things. I do have some detonation on the piston tops from a trigger issue back about 5 years ago. I felt it and shut off then bought a new ecu and changed the trigger. Never been an issue since. It never hurt the power, its made almost 80hp more since that incident but I will pull the bearing caps to take a look. If the bearings are damaged I will do a bottom end refresh. Head is being re conditioned at the moment and the block will be cleaned and checked to ensure it's flat. I'll go with a kameari gasket and see how it ends up. The other thing I'm not super keen on is the cylinder colours. I suspect this is from the inlet manifold. The plan will be to put it back together, retune and then stick a plazmaman billet inlet on it and retune. I'm happy with the power, if it makes a little more, then great, but I would rather just make everything more efficient at this stage.
    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
    • Does it also misfire equally when revving?   Josh is very correct in what you should do. The coilpack harness wiring loom itself is a known problem due to its age and the number of heat cycles it has gone through. Throwing parts at a vehicle to diagnose the issue isn't a smart or good way to do it. Secondly, you may have a bad coil pack, you pop replacements in, they fix that issue, but messing with the harness breaks it, so the issue persists. So now you think "well it wasn't the coil packs" and have to continue chasing your tail, potentially swapping back in your shit coil packs and returning the good ones (yes, I've seen people do this because 'it wasn't the problem' and they want to save money). And suddenly, you've got two issues with the same symptoms...   Diagnose, don't use the spare parts shotgun.
×
×
  • Create New...