Jump to content
SAU Community

Recommended Posts

Yeah cause Wayne has the only black 33 on the coast lol :D

I spoted a white 32 GTR yesterday, gave a too, near chatswood on the hwy

I think the white one was me. White rims, dark tints. Heading out to West Head for a run :) I yelled and waved back.

spotted heaps of r32's today on parra road. there was like 3 pretty close to each other and they didnt know it, like 2 gtr's and 1 gtst within 2-3 cars of each other and i dont think they knew it. on parra rd around 8:15 in auburn heading east.

Spotted a purple R33 GTR today near bankstown

and a hot purple R33 s2 at norwest blvd

i think the purple one mite be Kon...he's OMG-RLX on here...

Edited by Black Widow

in the space of 2 minutes spotted 3 lines @ lunch

1 white 33 with WA plates in bunnings car park

1 black 32 - mr 32 gt who always parks in company parking spots (used to do it to our spots)

1 black 34 turning left outside bunnings

edit - bunnings in Artarmon

This very tidy r32 has been around a lot lately. Has a Mines sticker on the bonnet.

One of the cleanest examples I have seen for a while, I'm enjoying it every time I walk past! Hi if you're on here!

post-39849-1203932807_thumb.jpg

Thats my mate Johns car. He's not on the forums.

spotted James (lingeringsoul)next to my car at street vision meet last sat arvo.

23022008121if1.jpg

Hey i know that white Proton with the fully sick interior, i think he has relatives across the street from me.

Whats the go with his car its turbocharged, do you know much about it?

Hey i know that white Proton with the fully sick interior, i think he has relatives across the street from me.

Whats the go with his car its turbocharged, do you know much about it?

i know abit about the white proton formerly "MYASIA"...i love myasia, thats the car that got me into the whole car scene

i am friends with the previous owner Brandon and i have been in that car a fair bit

its faster than my car at low gears but it runs out of puff at higher speeds (where the skyline keeps on pulling)

pm me if u want to know wats it running

Spotted "ZTUNED" pulling out of powerplay imports today.

That is one seriously wicked car in the flesh.

wonder what the insurance would cost?

Edited by Yo-Yo
Hey i know that white Proton with the fully sick interior, i think he has relatives across the street from me.

Whats the go with his car its turbocharged, do you know much about it?

not really, met the guy a few times already but never talked bout his car, just had a look lol.

Yes its turbocharged & it flutters hard lol

some more pics.

DSCF1707.jpg

IMG_0347.jpg

IMG_0365.jpg

IMG_0573.jpg

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yeah well per the video it took 15s for the stock unit to start up....even if I give it a few seconds discount for starting that is at least 12 sec before you get a reverse camera if you are trying to leave a park.  The android unit is way faster, but 2016 for the stock unit is a long time ago in consumer electronics
    • Yea that’s why I said ima test them with multimeter and see the reads.
    • Only at idle. Isn’t a problem when rev it seems.
    • @Haggerty This seems silly to ask, but are you confident in your ability to tune the Haltech?  
    • Next on the to-do list was an oil and filter change. Nothing exciting to add here except the oil filter is in a really stupid place (facing the engine mount/subframe/steering rack). GReddy do a relocation kit which puts it towards the gearbox, I would have preferred towards the front but there's obviously a lot more stuff there. Something I'll have to look at for the next service perhaps. First time using Valvoline oil, although I can't see it being any different to most other brands Nice... The oil filter location... At least the subframe wont rust any time soon I picked up a genuine fuel filter, this is part of the fuel pump assembly inside the fuel tank. Access can be found underneath the rear seat, you'll see this triangular cover Remove the 3x plastic 10mm nuts and lift the cover up, pushing the rubber grommet through The yellow fuel line clips push out in opposite directions, remove these completely. The two moulded fuel lines can now pull upwards to disconnect, along with the wire electrical plug. There's 8x 8mm bolts that secure the black retaining ring. The fuel pump assembly is now ready to lift out. Be mindful of the fuel hose on the side, the hose clamp on mine was catching the hose preventing it from lifting up The fuel pump/filter has an upper and lower section held on by 4 pressure clips. These did take a little bit of force, it sounded like the plastic tabs were going to break but they didn't (don't worry!) The lower section helps mount the fuel pump, there's a circular rubber gasket/grommet/seal thing on the bottom where the sock is. Undo the hose clip on the short fuel hose on the side to disconnect it from the 3 way distribution pipe to be able to lift the upper half away. Don't forget to unplug the fuel pump too! There's a few rubber O rings that will need transferring to the new filter housing, I show these in the video at the bottom of this write up. Reassembly is the reverse Here's a photo of the new filter installed, you'll be able to see where the tabs are more clearing against the yellow OEM plastic Once the assembly is re-installed, I turned the engine over a few times to help build up fuel pressure. I did panic when the car stopped turning over but I could hear the fuel pump making a noise. It eventually started and has been fine since. Found my 'lucky' coin underneath the rear seat too The Youtube video can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44&t=6s
×
×
  • Create New...