Jump to content
SAU Community

Recommended Posts

-access the CONSULT port, bottom right side of dash behind flip down door.

-ignition OFF

-ground bottom middle terminal using a wire.

-ignition ON

-observe flashes (also beeps) of ABS light

-it will start with '12', (1 long flash then 2 short.)

-it will then flash the fault codes.

-to clear the codes, whilst in this diagnostic mode, disconnect the grounded terminal, then ground it 3 or more times, for at least 2 sec, within 12.5 sec. restart diagnostic mode to check if thwey have been cleared. May take a few attempts before the codes clear.

21 Front right wheel sensor (open circuit)

22 Front right wheel sensor (short - circuit)

25 Front left wheel sensor (open circuit)

26 Front left wheel sensor (short circuit)

31 Rear right wheel sensor (short circuit)

32 Rear left wheel sensor (short circuit)

35 Rear left whel sensor (open circuit)

36 Rear left whell sensor (short circuit)

41 Front right outlet solenoid valve and circuit

42 Front right inlet solenoid valve and circuit

45 Front left outlet solenoid valve and circuit

46 Front left inlet solenoid valve and circuit

55 Rear outlet solenoid valve and circuit

56 Rear inlet solenoid valve and circuit

57 Battery voltage

61 ABS actuator motor and motor relay circuit

63 ABS acutuator relay circuit

64 FR & RR G sensor 1

65 FR & RR G sensor 2

66 FR & RR sensor 1 or 2

68 G sensor voltage

69 Side G sensor voltage

71 ATTESA E_TS PRO/ABS control unit and circuit

72 Throttle position sensor

73,74 E-TS/LSD actuator motor

76,77 Pressure switch

78 Air bleed switch

79 Oil level switch

91,92,93 E-TS solenoid

94,95,96 E-TS fail safe solenoid

97,98,99 LSD solenoid

Hey Mat, welcome to SAU, and to the Stagea section of the forums.

First things first, do a quick search for your problem in this section of the forums, and you should be at least be able to find a link with info for getting ECU codes. Once you do that, see if anything matches what's previously posted. If you can't find any details about what corresponds to the codes given, post the details on here and see if anyone else can help!

yeah ive searched the forums and everything ive tried hasnt worked.

ive tried the consult port and it doesnt stop flashing i counted 102 before i gave up.

i wouldnt think a slight tire differnce would affect the system.

there is a differnce by 2.06% but wouldnt think that would be enough to affect the system??

or am i wrong?

yeah ive searched the forums and everything ive tried hasnt worked.

ive tried the consult port and it doesnt stop flashing i counted 102 before i gave up.

i wouldnt think a slight tire differnce would affect the system.

there is a differnce by 2.06% but wouldnt think that would be enough to affect the system??

or am i wrong?

From the million times this has come up on this forum, I'd say stick to the same size rims/tyres for all 4 and you wont have any problems. The ATTESA system apparently doesn't like differing rolling diameter front vs rear OR differing tyre width...it allows enough leeway for uneven tyre wear, but thats about it.

yeah ive searched the forums and everything ive tried hasnt worked.

ive tried the consult port and it doesnt stop flashing i counted 102 before i gave up.

i wouldnt think a slight tire differnce would affect the system.

there is a differnce by 2.06% but wouldnt think that would be enough to affect the system??

or am i wrong?

flat(er) tyres also cause the jerkyness and even bald vs new tyres

see if you can throw on some rims from a different car which are all identical

  • 1 month later...

yeah i thought the same thing. ive tried the consult port and i even have a cable but i dont get any fault codes,

the fault clears as soon as i turn the car off, and the light wont come back on untill i drive about 20-30km's

ive noticed a small amount of fluid araound the bottle in the boot so ill drain it and check all the lines and replace the fluid.

  • 4 weeks later...

before you do anything make sure the fluid level in the ATTESA reservoir is between full and empty, and that you don't have any leaks so that the system can pressurise.

  • 6 months later...
  • 6 months later...
  • 4 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi from Canada, Both of my calipers are starting to fail. My car is a 2005 M35 Stagea ARX and I can't seem to find any parts or any cross reference caliper that would fit my car. Is there a company or a similar caliper that would fit and I could replace the OEM one. Or if anyone knows where I can find a new OEM. Any help is very appreciated. Let me know!
    • Maf is a question mark but TPS  I have set at 0.47, the fact that I’m getting proper voltage range out of it with the key on leads me to believe it’s functioning properly. I’m getting proper voltages on basically everything. I still need to look up voltage ranges for z32 maf and test that 
    • Honestly no not at all, but it’s a very basic tune, it’s stock injectors q45 tps and z32 maf. Other than that it’s a completely stock base map. The file is from nistune and from my understanding if it was tune related I would be able to unplug maf and tps and it would still start even if it was a really shitty start. I have tried starting it with coolant temp, maf, and tps unplugged none of those 3 togethor or individually changes anything 
    • 🏆 Skyline Supremacy Meets Mount Panorama Magic 🏆 Join SAU NSW as we take the long way to Bathurst, the home of GTR greatness. Saturday 30th August 2025 7:00AM Meeting Hanna Park North Richmond 7:30AM Departure Cruise Via Bells of Line Road 9:00AM Arrival to Stop 1: Golden Poplars Meadow Flat 9:45AM Arrival to Final Destination: Mount Panorama Motor Racing Circuit Meet Location: Hanna Park North Richmond Stop 1: Golden Poplars Meadow Flat Final Destination: Mount Panorama Motor Racing Circuit   *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • What does it look like with highway driving? And yes, I had a similar thought as Duncan. It looks quite similar in my Stagea and I have made myself accept it as normal. Might have to look into it some day   Highway gets as low as 10l/100km on my end so I'm not as worried about it being a mechanical issue. More likely just the tune on the haltech.
×
×
  • Create New...