Jump to content
SAU Community

Recommended Posts

they might sit nice but im not feelin the xt7's :)

haha dont worry man i test fitted some already (just to wide) and they looked awesome on the car

if i dont get them under $1k ill jsut paint my enkei's black or bronze for the moment

evo drivers in oz amuse me. they're either asians who have watched a bit too much initial D, or white boys who are WRC fans. the ironic bit is that both stereotypes are so protective of their precious cars that they won't take it hillclimbing etc and sit there stressing about a chip on the paintwork.

fuck off you sandy vagina'd poser douchebags. your car is not the fucking automotive messiah, it's a fucking lancer with a turbo and an extra LSD. you don't have fucking active yaw control so that you can better negotiate roundabouts. drive it like it was meant to be driven or give it here and walk to your fucking knitting lessons or book clubs or whatever fuck you ballbagless eunuchs seem to like doing for fun.

hrmmm go black ? lols

ps. lower it pls :)

haha i was about to get some tein s-techs to drop it

but one of the kents of evoOz fucked me over from buying them, was promised first dibs adn the kent sold them on me

evo drivers in oz amuse me. they're either asians who have watched a bit too much initial D, or white boys who are WRC fans. the ironic bit is that both stereotypes are so protective of their precious cars that they won't take it hillclimbing etc and sit there stressing about a chip on the paintwork.

fuck off you sandy vagina'd poser douchebags. your car is not the fucking automotive messiah, it's a fucking lancer with a turbo and an extra LSD. you don't have fucking active yaw control so that you can better negotiate roundabouts. drive it like it was meant to be driven or give it here and walk to your fucking knitting lessons or book clubs or whatever fuck you ballbagless eunuchs seem to like doing for fun.

ahahaha like im going to say what i really do up my street/back streets which is all dirt and pretty much a single lane rally course, why do you think it got so dirty :D

ahahaha like im going to say what i really do up my street/back streets which is all dirt and pretty much a single lane rally course, why do you think it got so dirty :D
i live on a dirt road, but i hate driving on it

i like clean cars, ive taken it down the road once it was soooo filthy afterwoods and dust was in everything.... never again

great story hansell.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ok guys thank you very much. GCG highflow it is then 🙂 
    • forgot to mention that when it does this it does not kill the engine, but I have not kept the pedal down long enough to let it, as I see no reason to beat up on it as its got to be something simple, small and dumb causing this.  And as soon as I let off pedal, the engine returns to its normal super smooth operation and rpms re-stabilize quickly, once below 4k. 
    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
×
×
  • Create New...