Jump to content
SAU Community

Recommended Posts

hi guys i installed a mechanical boost gauge yesterday so i could install a boost controller,

i was hoping that i could run a duel setup so i can run the standard boost then with the flick of a switch i could run 10psi, but after installing the gauge i took the car for a run and noticed its boosting at a constant 11psi !!!! not the standard 5psi.

so i opened the bonnet and looked every were to see if i could find a manual boost controller but there is none, my question is how could my car be running more boost without a boost controller, could it be modify ed or is there something possibly wrong ?

when i purchased the car they said it was stock but the turbo may have been a factory upgrade because the spool up sound is different to any they have had in ?

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

ive got a turbosmart dual stage boost controller for sale if you need it. 120 and its yours.

i never knew standard r34's to run 5 psi lol

isnt the reading in kpa?

so .5 kpa is 7psi... as i think 1 pound is 14 psi?

0.5KPA relative is 0.072PSi relative.

they run 5 psi up to 4500 then 7 psi to redline . it might have a r32 actuator on it . or most likely it had had the restrictor removed or drilled out . it the solenoid still plumbed in and wired in?

hi i had a look at the exhaust and i have 3" from the cat back and the cat and back pipe looks like its 2-2.5" ?? this is the best photo i could get with the bulky camera i have .

thanks again for your help people , sorry to start a debate about the standard psi im new to turbos and was told they run about 5psi standard! sorry my bad i was miss informed.

post-70954-1268557529_thumb.jpg

As someone said above, they run 5psi and switch to 7psi higher in the rev range.

That's the standard OP6 turbine housing you have there - compressor housing looks a little bit shiny but could just be nice and clean stock variant. I'd say your actuator has been fiddled with, or you have a leak in the vacuum line running to the actuator.

hey, sorry don't want to steal your thread mate but isn't the stock boost in an r34 gtt up round 11-12 psi? mine is running with no mods and the in car gauge is up there...

from what i have read on other posts its only ment to be 5psi then 7psi ???

unless thats for the r33? so im comfused as well because alot of people will tell you at 12psi your pushing your turbo to its limits and it may fail.

you maybe like me and posibly something has been done to it in japan by a previous owner.

I've seen 2/3 stock R34s on dynos around here and they all ran near 11psi with just exhaust - I don't recall even seeing any sign of dual boost levels, like the R33s have.... though its been a while. I do remember the ~11psi part (with no boost control) vividly though.

ok so should i replace the line ? how can i tell it it has a leak ? would it be louder at spool up ?

No harm in replacing it, it's only vacuum hose - very cheap stuff and easy to replace. You can use leak detector spray?

Yes you can hear a vacuum leak sometimes, which you may mistake for a spooling sound...however it is more than likely louder because you are running 11psi instead of 7psi. Now that people are mentioning it, perhaps R34 do run 11psi standard? They have about 20kw more than the R33 RB25 but I always put that down to the variable valve timing.

Yup mine boosts to between 0.6-0.7 on the standard guage. On a dyno it shows a constant 9psi without any boost control mods at all.

do you have any exhaust mods? that might be the difference? just guessing tho

34's dont run the solenoid like 33's AFAIK

The 34's I have driven have only ever boosted to about .6 max - with no sign of a switch from 5-7psi...

They definitely have a solenoid; You can both see on the gauge and feel the power change on my R34 at 4500rpm (in the wet, I've had it cause the rear end to slide out as the boost increased at 4500rpm).

With a 3" turbo-back exhaust and k&n panel filter, mine will do 0.5bar (7psi) up till 4500rpm, then 0.6bar (8.7psi) to redline according to the MFD.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • 2001 BE5D Subaru Legacy B4 RSK (3rd gen) EJ208 (pink injector) Twin Turbo 280PS 5-speed manual Full time 4WD "RSK" grade which means all of the above LQC option which means stock rear spoiler  I got it primarily to export to someone outside Japan who was interested. These BE5 Legacy B4 RSKs are going through a bit of a resurgence right know in Japan as they are one of the few cars from the "turbo, manual, RWD/4WD, 280hp gentleman's agreement era" cars that don't require stupid money to purchase. Which for some people might be a good opportunity to get as a base for restoration. If I can't find anyone to purchase it I will certainly be doing that myself over the long term. Why? Because it's properly fast in stock form, handles well enough for a GT sedan, there's still enough aftermarket and (if you can wait a while) genuine part support to make it a restoration candidate (<-- that will only get worse over time so it's a case of do it now or choose get a BL5 4th Gen). Mechanically it's fine, has only 89,200kms on the odometer. The problem with this car is that the body and exterior trims are weathered from at least the last 10 years being parked outdoors. I'm the 3rd owner, the first owner was the one that had it for 14 years and barely drove it, had a low-speed front impact (which didn't damage anything behind the radiator support) and got it fixed and sold it. The 2nd owner put most of the kms on it and parked it outside for the last 10 years, hence the door rubbers have seen better days but if you overlook those cosmetic details, it presents pretty nicely. There is some minor rust on the LH rear wheel arch which I'll have looked at too at some stage.  Also as you'd expect from a car this age, the clear top coat is gone, leaving a satin finish on the roof.  Mechanically it's fine (as you would expect from a car with less than 100K kms) but the steering does feel slightly vague around the centre position at higher speeds. So first on the list is to get the steering rack bushes looked at. There's also the Lock button on the remote which doesn't work, but the Open button does.... it means that the anti-theft system thinks it's always open? It seems like if you open the car and don't start the engine within 3 mins or so the anti-theft kicks in again without any beeps or signals. So if you got to start it after that, it won't. You have to push the open button again. That's how I understand it anyway. Just a small irritation but not a big problem to sort out. There's only one mod, the Wangan SPL muffler. Just a tad louder than stock. It's a really good mod for those who don't want to wake the neighbours but still want to hear a more prominent unequal length header EJ20 sound. Anyway I hope to get all those things done eventually, that is unless someone wanted to import it to their country from Japan (where I live). I'm open for negotiations as I really would like a Skyline... but this will definitely suffice in the meantime 🙂 *Disclaimer: This is how I picked it up from the dealer, minus the stuff on the back seat. I haven't cleaned the engine bay or done a thorough exterior clean, aside from spray painting the wipers. 
    • Wow, even with the Audi logo centre caps. I love OEM wheel mismatches. 
    • Welcome!  Can't go wrong with a Stag.
    • Looks good. Nice height.
    • Hey all, a little help from the Stagea hive mind plz.. I'm days away from buying either a 2002 Stagea 250tRS AR-X Four, premium leather, power seats and all the old switches etc that go with it, or a 2002 Stagea 250tRS VR-X Four AERO, pov pack, cloth seats etc, with coil overs, sports zorst, comes with original zorst and suspension and parts. (I think I've got the models right?) Both are VQ25DET, have 160000kms, both straight no rust both with $2000+ in recent servicing receipts, both ride on aftermarket 18" rims. The Aero has a replaced turbo as well. I like the cool factor of the Aero car but the AR-X has never been modified. Neither have been driven hardly at all in the last 5 years. Any thoughts on which one or does it come down to personal preference? davemoto 
×
×
  • Create New...