Jump to content
SAU Community

Recommended Posts

  • Replies 85
  • Created
  • Last Reply

Top Posters In This Topic

Ok, So since the helmet that I use (Thanks Paul) still has Green Wang pump racing on it. I think the team will have to be re-united.. Hopefully Scotty won't burn out the clutch this time.. :laugh:))))))

Team Green Wang Pump Racing FTW...

  • 2 weeks later...

as maka reported, the dust has been blown off the green wang pump and i just tested it out... shes a beut!

looking at the total lack of trash talking happening here, i can see there is a total lack of team honor and that can only spell TGWP dominance.

Mike... youll need to drop more than 20kg of that super structure to make any difference... i think i saw the making of mike on the discovery channel "engineering marvels"

Bard... i know you can drive... but... with poor team selection, one can only challenge your decision making skills so clearly your mind wont be there on race day

Paul... now your a dad you will likely have a baby seat strapped to the back of your kart and a "baby on board" sticker so i expect to pass you on a regular basis as you chug around the track at "school zone speed" taking notes of hoon drivers to complain about

Tom... just crash

Scott McKickass

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...