Jump to content
SAU Community

Recommended Posts

Hey guys, it's on again!!! All you need is a helmet, $30 and a reasonably roadworthy car!! (if you need info on helmets pm me.)

Last time I went I had a blast, would recommend it for everyone. Drifting's not allowed but I was sideways most of the day anyway. :)

Might organise a cruise if there is enough interest but it's a 2 1/2 hour drive so Ryan and I are thinking of staying somewhere closer for the night.

Hope to see some SAUers on the track!

c

Winton Motor Raceway would like to invite you and your family to participate in the FUN DAY being held on Saturday the 3rd July, 2010.

Saturday 3rd July, 2010

Gates Open: 8.00am

Cost: $30 per participant

When arriving at the circuit, participants should set up for the day in the support paddock area. In addition to the carports available in this area, 30 powered garages (shared) will be available to hire for the day. To avoid disappointment on the day participants should contact the Winton Administration Office prior to the event if they wish to hire a garage.

All participants (including passengers) must register for the day from 8.30am at the Dutton’s Paddock Office.

Participants must wear flame retardant clothing, ie. cotton, wool, etc. No Nylon. When driving on the circuit, participants must wear clothing that covers them from the neck to wrist to ankle and closed shoes (no thongs, sandals, etc). Helmets must be worn for on track activity.

Cars must have a safety check before going onto the circuit, so we ask that you ensure your vehicle is in a safe roadworthy or race worthy condition for the duration of the activity. No oil leaks or fuel leaks. All cars must be fitted with an effective muffler and must not exceed 95dB (A). This event is for cars only.

The day will be structured with sessions for driver only and sessions for driver and passengers. There will be a compulsory driver briefing at 10.00am, any competitors that are unable to attend the drivers briefing must be briefed by a Winton Official, before going onto the circuit.

Come along and join in the fun at Winton Motor Raceway.

Link to comment
https://www.sau.com.au/forums/topic/326431-family-fun-day-at-winton-raceway/
Share on other sites

  • Replies 121
  • Created
  • Last Reply

Top Posters In This Topic

Is this all day?

Also, When I last raced on winton we did 20 min sessions of cars then 20 min sessions of bikes....continuing on all day.... something similar?

ooh, do dirt bike (as in off road motorbike) helmets count?

Is this all day?

Also, When I last raced on winton we did 20 min sessions of cars then 20 min sessions of bikes....continuing on all day.... something similar?

ooh, do dirt bike (as in off road motorbike) helmets count?

It's all day, they only do cars on this one. I think I remember someone there wearing a dirt helmet, but maybe give them a ring.

Will check out helmet prices and post up some stuff, have do wait for business hours unfortunately :(

hmmm for free yeah? LOL

how much are you asking for it huni?

probably around 2k for turbo .8rear .5 front, manifold, dump, braided oil feed line and baonjo's with barbs for water feed and return lines.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I wasn’t able to replicate the sound anymore. It was a one time sound so maybe it was just coincidence but it was like small pebbles being dropped in a coke can.   should I try cleaning the MAF? It could be it’s functioning but dirty? I don’t know.
    • Update 4: Hi all. The car drives again! Haven't driven for long, only to store it in the garage again, but the test drive was successful. The coolant and oil leaks seem to be fixed for now. Temps on the engine were also very good, while moving I never even saw 80C water during the approx. 30 minute drive. Ate up all the coolant in the reservoir though so will have to fill that even more when I go to the car next time. One thing that pisses me off is that the RPM gauge is still f**ked, I even resoldered the board twice and used copper paste on the silly screws that are used as connections. Next time I take it out I'll take apart the board and fit new components, I'll see if I can get a replacement IC for it.  I have an appointment set for 22nd of September for the engine tune to 370hp. Alignment also still needs to be done. My hope is that I can get all the legal stuff over with by the end of this season. Anyone of you have advice regarding intercoolers? Currently there is an APEXI core fitted, one of those weird hybrid ones, 600x270x76. I don't think it's bad but it's not new and now I still have the chance to change it now to legally include it in the paperwork. Only issue is that the only options that would arrive in time are a HKS Type R intercooler or generic Ebay spec intercoolers comparable to a JustJap one. Ideally I'd order a Plazmaman but it takes over a month to receive which would mean making the car legal has to wait until next season. Would love to hear some input on this. Same story for my injectors, the previous owner was a nunce and put ID 1050x on the engine. They work but are obviously not ideal at "normal" power levels. But I don't see a reason to change them unless the tuner says it's necessary. I read online before buying a different exhaust that the top secret style rear diffusers won't fit due to the size of the rear resonators. My buddy and I made it work by slightly "adjusting the shape" of the mounting bracket and making some spacers out of 3d print for the mounting bolts. Fits like a charm. Just putting this here in case someone has this problem. Even the hefty HKS Silent Hi Power rear can fits without hitting anything.
    • Well they got my money but they are not getting my gearbox ! 
    • It's needed for rolling idle up, and I think it is a decider on VCT also.
    • I mean, not really. Link ECU's can absolutely still have errors from the ECU thinking it's getting a sensor it's not expecting. I would imagine the speed at the ECU level in Nistune does absolutely nothing anyway? I assume the ECU does not do any fancy TC stuff with regards to front+rear wheel speed or anything of that like anyway. Someone who uses Nistune may be more fluent in it. 
×
×
  • Create New...