Jump to content
SAU Community

Recommended Posts

Is that water vapour coming of the rear wing of the vodaphone cars when they come done the back straight? It doesn't seem to be there on any of the other cars

Most of the cars are doing it, and yes, it's water vapour

hamo did a good job at trying to hit the force india then. wouldn't be suprised if he gets into shit after that (possibly post race)

What's the chances of Hamilton getting a drive through for the flick spin.

how good are we? LOL

Most of the cars are doing it, and yes, it's water vapour

it's caused by a low pressure area allowing the moisture to condense a bit. you see it quite a bit, just on wet races where it's a bit darker you notice it more. you also see it from jet fighters when they bank, as well as sometimes in the redbull air races.

I figured they'd wait until post-race for Hamilton, but not surprised that he got done.

Pitting for inters looks like a strategic blunder ... it's so hard to call that though. Get it right and you're a hero, get it wrong and you throw away 30 seconds.

How many promises to go to the end without more adds have they broken?

well at the ad break before the last one they said "1 more after this one", so they will only have broken the promise if they go to another ad break from now on.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
    • Yes. You will need to get the original boost sensor and wire it in. That is.... if you plan to use a stock ECU - even a Nistuned ECU. The Nissan ECU will not operate correctly without it connected. And yes, it will do annoying stuff like you are experiencing. You will almost certainly be better off with some aftermarket ECU, than trying to hunt down rare sensors.
    • Ok so ABS/TCS is "not" the problem. Yeah i know now about the ABS with Nistune(i told that to the Nistune guy) but iam not 100% why or why i dont have ABS. ABS cube is in the engine (always has been) but i had braked couple of times rly hard and brakes just locked and scream. Does all Skylines have ABS cube? That boost sensor https://www.sau.com.au/forums/topic/367633-wtb-r34-gtt-turbo-pressure-sensor-pics-inside/ Is this it? I need to ask but i have a picture of engine bay and i do not see that (100% is not in that place) If i do not have this the car can do what mine is?(cutting around 4000 rpm) Here is the pic of my engine bay(only one i have) BUT i think i dont have that cuz loom was used from my RB20DE NEO and i know (obviously) that it does not have boost control or any wire to that...) so maybe that is the problem? (i dont know for 100% if that car where the engine is from had that)...but i dont have the loom from that
    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
×
×
  • Create New...