Jump to content
SAU Community

Recommended Posts

where did you get the turbo beanie?

hows it holding up? the ones i have seen don't last too long and have a habit of smoking really bad after a while.

Ebay, it's branded autobahn88...

So far so good, between it and the heat wrap on the dump it smoked for a while but now has cleared up and is fine :)

w00t all set for the T67, just waiting on some cash 2 morrow and it will be orderd. then its just a matter of a new dump/inlet and changing my intercooler piping a bit :D fun times ahead.

thanks for this build thread man, it is a good read and hopefully i gan get the 350rwkw im aiming for this time round and it tuned at status also.

Failed to make it down to the drags this week because I tried to reinstall the rear stock suspension to get a bit of squat in the rear end and because of all the alignment changes the bottom seat of the spring hits against the upper camber arm!

So I had a bit of a hissy fit and went f**k it I'm not going down at all and left the rear end in bits and on jack stands...

Going to get my shit together tonight and put the coilovers back in and then probably just raise the rear end a inch or 2 and run it like that down the drags with some MT ET streets, probably won't be a good time due to getting kicked out as soon as you run a 11.99 or better but will be good to see how high the mph will be.

Fingers crossed for at least a low 11 at 130+mph

Failed to make it down to the drags this week because I tried to reinstall the rear stock suspension to get a bit of squat in the rear end and because of all the alignment changes the bottom seat of the spring hits against the upper camber arm!

So I had a bit of a hissy fit and went f**k it I'm not going down at all and left the rear end in bits and on jack stands...

Going to get my shit together tonight and put the coilovers back in and then probably just raise the rear end a inch or 2 and run it like that down the drags with some MT ET streets, probably won't be a good time due to getting kicked out as soon as you run a 11.99 or better but will be good to see how high the mph will be.

Fingers crossed for at least a low 11 at 130+mph

Ah damm... So are you planning on taking it down next wednesday?

Well drags went ok, didn't get the best launch in the world but went for it anyway, ended up getting kicked out so only 1 pass on power.

Ran a 11.03 @ 132.5mph and the ANDRA official kicked me out and said to not come back without 10.99 or better regulations.

So close but no 10, at least the mph was healthy :)

Fck yeah mate, thats awesome. what tread did you use? with the coilovers or stock?

Coilovers, stock suspension hits on camber arms now. MT ET streets 255/50/16

thats moving. I think my t67 with 10 cm housing is goung on with rhe cams and e85. will see what abuse it can take and whether the lil 20 can keep on the boil down the qtr. god knows it will ne a shitty track setup

Mine was set up for track really, all I did was would the rears up 15mm and bolted on tyres. Those ET streets are surprisingly grippy haha

I always thought it was a 10.99 you needed before getting the boot, either way a very good time

11.99 you need a harness, tailshaft loop and andra licence etc... Because I was so close to a ten and mph was high he said I had to sort the 10.99 or quicker requirements as well, so cage plus lots more

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...