Jump to content
SAU Community

Diagoins Of A Fauly Coil Pack


Recommended Posts

Guest trikdoutvl

Ok so motorvation is 2 days away and my car decides to sound like a wrx again. exact same thing that happened last year. It was a coil pack. So my question is how do you diagions a fkd a coil pack???? The best way I can describe it is the motor sounds like a wrx and it has fk all power.

Link to comment
https://www.sau.com.au/forums/topic/350032-diagoins-of-a-fauly-coil-pack/
Share on other sites

Ok so motorvation is 2 days away and my car decides to sound like a wrx again. exact same thing that happened last year. It was a coil pack. So my question is how do you diagions a fkd a coil pack???? The best way I can describe it is the motor sounds like a wrx and it has fk all power.

sounds like a wrx and no power... you sure you did not get in a wrx :P

you can visually inspect by running your finger nail around it and see if there is any hair line fracture...

you can do the old turn the car over with the coil pack out and see if any spark excapes...

also think you can check the resistance and make sure all are even...

only other way is to start the car with one off at a time and see which one made no difference (ie you will be running on 5 cylinders with one buggered and as you remove working ones you should go to 4 running cylinders)..

resistance and visual damage does not always mean much , i have seen many that look in perfect condition , measure fine and still die under load

also they often spark at idle but break down under full load

best way to tell is to get a good coil and swap them out one by one and test under load

did you replace all the coil packs with something decent like splitfires last time or did you just replace the 1 with a stock one ?

if so get some splitfires and never worry about it again

if the problem is present on idle just unplug the coilpacks 1 by 1, whichever is the one that doesnt make a difference to how it runs is obviously the dud one.

swap that over to another cylinder and see if the problem has carried over to that cylinder. if it does then that means the coilpack is screwed.

if the problem is still in that cylinder, that means your problem is elsewhere

  • Like 1

Should be careful when checking coilpacks. the way Snozzle mentioned, may blow the coilpack driver (the box that sits at the end of the head).

If you can get to the injectors, diconnect them one at a time to see which cylinder it is. Much safer option unless you know how to check the coilpacks properly.

I would recommend splitfires, never failed on me once with 1.1 gapping and lots of boost.

also don't jump to the coilpacks answer whenever you have a missfiring problem... there are many other possible causes as anything to do with fuel / timing / spark can cause symptoms similar to coilpacks..

personally i've had 3 different occasions when my car was missing... each time the problem was not the coilpacks, despite everyone on the forums suggesting they were.

(mine turned out to be the CAS, then the AFM and then a sticky valve... each were 6 months to a year apart)

also u didnt happen to wash ur engine bay recently? water in the spark plug wells.... coincidently it took 2 days after i washed my engine before misfiring occured and only to find out it was water after a new set of coils had arrive ...Doh!

  • 7 months later...
  • 7 years later...

I started my car last night to visually check my coil packs due to a surging issue, im glade i did, even at idle i could see the spark jumping out onto the motor, so she is gunna sit until I get my new ones, my general rule of thumb is if 1 is on the way out replace the lot, for example if a shockie needs replacement i do all 4 at once

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Before starting any work, we attempted to adjust the tune. However even after adjusting it to certain extremes like completely stopping fuel, it had no effect. What fixed it was removing the Nistune Board and installing the original EPROM instead. This immediately fixed the issue. Everything should have been fine with the Nistune Board installation, so I am unsure why it has caused a problem. The soldered connector is also properly soldered. This worked when I first got the 550cc injectors, before cleaning, but that may have been a coincidence.  We ended up not installing the fuel pump hanger (at least for now). So currently running stock injectors, stock fuel pump, stock fuel pump hanger – Well everything stock except the exhaust. Now I have around €1400 in Nistune, Injectors, and Hanger collecting dust for the time being, perhaps I'll install them in the future. For now I'll enjoy the car as is 😁 Thanks a lot for all your assistance, I really appreciate all the help you have given me.
    • The turbo can’t be the issue. They’re proven to make much much power than you’re making. There is something in the setup that isn’t correct. - has the exhaust got any silly step downs? - what exhaust manifold?
    • Ok, just the way you wrote it made it look like you had the stagger the wrong way around 
    • I was getting anxious with the DVLA not knowing if the paperwork is fine or not, so I rang them. No update had been given, but I  was reassured that providing the box was ticked on the V750 then the application will go through fine. I've been checking the DVLA website pretty much every day, in the hope that it would have been done. Fast forward to Monday 29th  and I was greeted with a new screen on the check, and it finally showed as Taxed and MOT'd, woohoo! The car was in desperate need of a clean, not knowing when this day was coming it was put off. As far as I was concerned I had another 3 weeks  I'm not normally one for using snow foam, but I wanted to give it another try It hasn't cleaned up too bad considering it's 21 years old and lived on a boat for a number of weeks. The personalised number plate is J2 XBK, an illegally spaced number plate would have it read J2X BK. BK could either represent  the colour black or Baker, which is my surname. I filmed the first drive, the Youtube link will be at the end. I used the same driving route I did with the 323F V6 when I had a new exhaust installed, heres a couple of photos A few more since then Youtube video can be viewed here: https://www.youtube.com/watch?v=TjkFHPzjGDw
×
×
  • Create New...