Jump to content
SAU Community

Recommended Posts

Have some r34 gtr wheels with tyres for sale. Some gutter rash but still look good. Tyres are 235 45 18 federal fronts are about 70 percent rears are pretty bald. 1100 o.n.o and a full set of r34 gtr suspension in good working order for 300 o.n.o txt 0420945669

post-89345-0-93836000-1417513368_thumb.jpg

post-89345-0-03640000-1417513389_thumb.jpg

post-89345-0-04668600-1417513408_thumb.jpg

post-89345-0-42304300-1417513424_thumb.jpg

post-89345-0-43785800-1417513458_thumb.jpg

  • 2 weeks later...
  • 2 weeks later...

fs

r32 manual tailshaft 100

r32 gtr front hubs camber arm etc 100 a side

r32 gtr abs unit 150

r32 gtr standard intercooler brackets 50

r32 gtr brake duct plasticss 100

r32 wiper motor 40

180 tailights and centre garnish 50 a set

180/s13 door complete minus trim 50

r33 hks super dragger exhaust 200

r32 glass full set

bare rb20 intake mani 20

rb25 neo intake mani complete 150

r33 centre dash vents 60

  • 3 weeks later...

up for sale is my pride and joy, high powered performance gtst. which is also featured in the zoom magazine, previous owner had set this beast as a track car, also spending a lot of $$$ on it has one at import monster sau nats 2012 for quickest 800m mod 2wd class.

also at import monster sau nats 2012 800m highest speed mod 2wd class.

there is no back seats and carpet had been removed, has a bonds half cage $700 installed

has two r34 gtr bucket seats.

gtr rear end

omp race spec stearing wheel

a set of $700 defi din gage for oil,press,water,oil,temp

has a zetronic ethanol display screen $500

nismo gtr 320km cluster white $1000

phantom boost gauge $220

fully enginerrd certificates so hassall free

motor rb25 30 to4z turbo water and oil cooled

2000cc injectors areo flow fuel rail

all braided lines runs from engine to the boot and connects to a 5 ltr sard fuel surge tank with x2 walbro 450 in tank pumps

nismo in tank fuel pump to exterior

has an immobiliser built in too

x2 fuel location for exterior pumps

also has an e flex sensor so you can use petrol or e85 sensor and computer does the rest.

huge plenom with qhf 90 mm throttle body

Ross cas full balanced

drilled out oil remains blow off is plumped back

blisten shocks all new bushes

sway bars in boot engine bay under Neath sway bars

r33gtr wheels with brand be hankook tyres $1500 for set of 4

response head unit alpine speakers

brakes upgrade to dixcel type gs slotted rotors with zpads $2500

has also just put in a PPG dog box 1st to 4 gear straight cut 5 normal gear $8500

also has a nismo twin plate coper mix clutch but good friend jim berry had it supped up for me costing $3000 but strong guarantee it will last

r33gtr rear end 4:11

also eagle conrods, je pistons, custom exhaust camshaft (256deg) single coil up rated springs drain back vents on head drilled out oil returns rb26 cam covers with mines baffles external oil feed1mm restrictions full balanced QF45 throttle body high energy oil sump, tomei oil pump, factory Ross cass balancer, gready intake manifold, custom front mount inter cooler, Phoenix alloy radiator, custom 3.5 inch 5zigen exhaust system, high current igniter, link g4 plug in engine management system with link 2bar map sensor gready profec and electronic boost controller

the whole e85 fuel system cost $7600

car mad 450kw 601hp ran 11.08 at creek with old box be easy 10z with new box

car has receipt for every thing no joy rides no time wasters $27000 no less over 60k worth of grunt and power munches any thing on the road on low boost.

car also is featured in zoom mag custom plates SKYLNE also has 3 boost settings off is 14 psi low is 21 psi and a high 26 psi

call me on

0437797237

post-120788-14212412435469_thumb.jpg

Pair of GENUINE Bride DIGO-R seats and rails for R33 GTS-T, purchased from Japanese Import Spares 18 months ago, seats are immaculate, no rips/tears/stains etc, just a little dusty from car being in storage.
Selling due to going to Cage and Fixed seat.
Retail for $1K a seat, and $200+ per rail, selling for $1200 as a complete bolt in package. No separating the pair, nor the rails.

034.jpg

Contact Ben on 0439 888 043, or PM here, Car is in storage @ pooraka but seats will be removed tomorrow and can picked up from modbury. Can also help with delivery.

Pair of 17x8 +36 wheels for sale. They have 'Hinodex' and Japan stamped on the back so I assume that's the brand (not a clue as they came with the car).

Currently have Federal RSR 595's on them in 205/50/17. Have plenty of tread left (99% of use was daily driving).

Asking $300 ono (don't be affraid to throw me an offer).

Located SE Adelaide hills.

Cheers, Brenton.

post-96537-0-39526200-1421827753_thumb.jpg post-96537-0-69868400-1421827776_thumb.jpg post-96537-0-84433900-1421827797_thumb.jpg

FS SA

R32 gtr door cards

customised to hold duel front speakers

flocking embossed with GTR logo

they came as spares with my car and they seem to have screws holding one sides trim, so not %100 condition
whats pictured is whats available.

$100 for both.

20150120_155523_zpswttly8lj.jpg20150120_155602_zps1vdala35.jpg

Pair of 17x8 +36 wheels for sale. They have 'Hinodex' and Japan stamped on the back so I assume that's the brand (not a clue as they came with the car).

Currently have Federal RSR 595's on them in 205/50/17. Have plenty of tread left (99% of use was daily driving).

Asking $300 ono (don't be affraid to throw me an offer).

Located SE Adelaide hills.

Cheers, Brenton.

attachicon.gifDSC_0025.JPG attachicon.gifDSC_0026.JPG attachicon.gif10937406_10206035340231886_1181093836_n.jpg

Price drop $250.

whats involved in getting these in a 32gtr as far as the rails do you know?

Should be a straight swap, I've had two mates put 32 gtr seats in 33 gtst so the reverse swap will fit

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Starter motors used to use the weight of metal (magnets) to provide torque. Now they use (more) current instead. This. It's completely normal.
    • So thing that had me stumped, but I think is OK....is that when it was up in the air, in neutral I had it running to bleed to coolant while I put the wheels back on. I noticed the rears were turning (slowly) which I'd never seen before 20250928_163512.mp4     Because there had been an issue with clutch slip due to pedal adjustment on the dyno, I assumed there was still and issue so spent some quality time upside down under the dash adjusting the pedal....but no matter what I did the wheels still turned in neutral. Even disconnected the master cylinder to pedal rod and same. In despair, I even removed the clutch slave so there was no chance of any preload causing it.....still happened. So either: 1. Something is not right in the bellhousing, or 2. Its a thing sometimes with cold, thick gearbox oil Internet says it might be 2, I hope so!
    • OK, few more things sorted and it is ready for a shakedown on 10-Oct, with one weird thing. Changed the run in oil and filter for the good stuff. 8l came out, about 8.5 went in with filter so that looks all good. Changed the starter (again), this time for a brand new one, works good. Interesting that the Taaaarks one is shorter than factory but spins harder, I guess electronics have moved on a little in the last 30 years. Will be nice to have a bit of extra space under there. Put the timing cover back on, and noted where the cam gears were set as a record.  Will need to double check the timing but it is pretty close. Also put the coil pack cover and intake snorkel back on. Exhaust Inlet Changed the water out for coolant, bled up nicely. Removed the rear brake pads (well worn factory sumitomo ones!), gave the hardware a good clean and reassembled. I've put bendix XP on the back again because the price is excellent at $150 a set and they worked well on the V37. Front pads have plenty so no issue there
    • Mine is all -12, I’m running a dry sump in a billet block though 
×
×
  • Create New...