Jump to content
SAU Community

Recommended Posts

Righto ladies

Anyway that last group buy actually cost the supplier money so I have asked again to revise the price to make it worth his while

The last one most people were happy, some people requested additional camber (eg ability to make them shorter)

I have requested if we get 10 people that they make them slightly thicker (stronger) and for additional camber adjustment.

Please not there is only so much you can do so if you want the ultimate camber solution give me a bell (involves mods to your sub frame)

We need ten orders, price is $550

I won’t f**k everyone around buy saying they will be ready in a week. So I am going to say once we have ten orders it will be three months

If it turns out quicker then so be it.

they look like this

frontarm4zk3.jpg

please note they are made by a australian engineering company and the price and quality is refected in that.. eg not china crap

Basically let’s say 250 up front then 320 including delivery when they are ready

bank details peter carruthers

bsb 112-879

acc 428 965 807

people who want in below

1 fatz

2 sbr

3 willis

4 sav man

5 endless

6 spirom

7

8

9

10

  • 4 weeks later...

hektic strong?

seriously though, have they have any serious testing? Lots of aftermarket ones break, and it's a horrible way to retire from an event. Assuming you urvive the accident.

One of the local circuit racers down here runs these (fastest car in the state), and he says these are by far the best he has ever seen. Stronger, and more durable.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yes, I know🙄 but the sequential is not in my budget... don't want to reduce power neither, so looks like I'm stuck in the rabbit hole🤣
    • You’ll be very upset when you bust that too not to mention the gearing totally sucks. Don’t do it.
    • Is the panel filter one that is oiled? Have you ever cleaned or touched the AFM?
    • So.... the K&N air box thingo was too big, ended up gifting it to a mate, well, by gifting it he actually supplied food and beer at the pub,  which was nice, as it will not sit on a shelf in the garage for the next 10 years I did trim up some of the existing stuff to neaten it all up and gave it some wrinkle paint, unfortunately it currently has a used and abused mish mash of different types of hose clamps, 4 big fat T bolt type (shit), and a few normal clamps of vairing sizes and brands, but..... only until the 6 constant tension black worm clamps that I ordered from EFI solutions turn up next week Currently the current hose clamps are triggering me hard, LOL Is this the final version, probably not, I really want just 2 silicone pieces, a straight bit of silicone from the filter to the MAF is easy and will happen as soon as I head into Just Jap tomorrow, the problematic part is a 30° silicone bend from the MAF to the TB that I can connect the engine breather from the head, I found that there are bulk head fittings for boat bilge pumps that should work, but until I can get a 30° silicone bend the alloy pipe, and the 11ty thousand hose clamps, are there for the foreseeable future 4 hose clamps are golden, 6 are grudgingly acceptable, the 8 currently holding it all together is just taking the piss    I've also ordered 60 more retaining wall blocks for the front yard, I mis-gonculated the height that was required to get above the base of the Photinia's (red robin's) that are the hedge behind the front fence, currently it is 2 blocks high, and about 1/2 a block short, so going 3 blocks high will be above the base of the red robin's, and allow some room for mulch
×
×
  • Create New...