Jump to content
SAU Community

Recommended Posts

the last time this was tried, there wasn't enough notice and not a big turn-out from what i heard. will be good to put some faces to the cars i see around this area and the names i see on the forums...

so here it goes again:

i though the north-west guys in here could have a meetup at the Watergardens Hotel for some beers or food. they do lunch/dinner buffet's or they have a bar around the back with plenty of beer on tap.

we could have it on a friday night for beers/dinner or saturday day for lunch (beers if you're keen!). would think avoiding saturday night would be good to avoid dikheads...

Friday May 7th / Saturday May 8th

PLENTY OF NOTICE GIVEN!

anyone like the idea?

who's in...

cheers,

Warren.

Link to comment
https://www.sau.com.au/forums/topic/38002-north-west-meetup-watergardens-hotel/
Share on other sites

Done. All you have to do mention is food and i am there!

Sat arvo IMO would be best, do a bite of lunch, perfect.

Friday nights are too hard after work for some people.

Also, if you wanna organise this yourself, get some melway ref's etc.

As i dare say some others from the otherside of town would definately join us :D

And it makes life a bit easier!

Lemme know if you need help - ash

awesome... 1 out of 1

i like the idea of lunch better also...

If you want to help then i would be more than grateful ash. i think if we can just get some intrest going first then from there we can make a 'how to get there' sheet and make a booking a the hotel for the food. and luckily the carpark is big enough to hold lots of cars for us...

Waz.

awesome... 1 out of 1

i like the idea of lunch better also...  

If you want to help then i would be more than grateful ash. i think if we can just get some intrest going first then from there we can make a 'how to get there' sheet and make a booking a the hotel for the food. and luckily the carpark is big enough to hold lots of cars for us...

Waz.

ill come past for a look....prob sat day/afternoon is lookinjg good.....that all u can eat powwwwa did damage last time bloated!

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...