Jump to content
SAU Community

Recommended Posts

I'm with Bob buy them. It is inevitable that coils on a neo will fail.

I am not usually a fan of buying parts just in case but there is almost no downside in buying stock coils for that price. Make sure you buy coils for an R34GT-t / neo RB25DET not the R33 in that Ebay advert.

Alternatively buy a can of crc urethane seal coat and give the coils a good even spray it will keep you going for a good while in most cases.

Definitely get a new fuel pump - Deatschwerks, Denso, Nismo, Bosch 044 and wire it directly for full voltage (with a relay - tutorials on this site) and change your fuel filter. Do you have a high flow panel filter? Whatever air filter you use check to see if it needs replacing.

I reckon I'll do my fuel pump before I get the Nistune. Which one is regarded to be the best?

The Walbro GSS-342 seems popular, but I've read good things about the Nismo and Deatschwerks to!

The walbro's are good (If you get a legit one) but only up to around 20 psi, for boost above that I would recommend either of the other pumps. What are your power goals?

Hmm, sounds like the Walbro would be suitable - I'm not looking to set the world alight...

I reckon I'll do my fuel pump before I get the Nistune. Which one is regarded to be the best?

The Walbro GSS-342 seems popular, but I've read good things about the Nismo and Deatschwerks to!

I got the deatschwerks, hardly breaks the bank at around $215 delivered, and small like the walbro

cheers

darren

my GSS342 is not to noisy, makes a bit of a buzz from time to time, i put rubber inserts in my cradle to stop vibration and noise(R33 Skyline).

i have a few mods planned for the year for my s2 RS4S.

walbro GSS342

nismo injectors

splitfire coilpacks

HPI FMIC

z32 AFM

TD06H-20G (internally gated version with replacable actuator springs - not chasing to much power)

tomei oversize metal headgasket - so i can run 16-18 psi through the neo.

ECU - probably a nistune, wasnt real happy with my powerFC.

i think that should make me a tidy 250awkw without pushing the engine to hard.

Edited by OMY31T
  • 2 weeks later...

Cheers thanks for the info.....Yeah I currently have a flat spot at 5000rpm thinking its the coils tried taping them up as well as a high temp sealant ...with no change....I just don't want to get the car on the dyno and something like that fail and have to get it re tuned later........Change spark plugs recently and re gaped them to

I've got a pod filter and in the proces of making a cold air box for it.....

Thanks again ....

Flat spot is the tune. Cool packs break down. Of you can get new OEM cheap, do it now, has to be done at somepoint and means you aren't risking a tuning session.

Pumps: nismo or bosch

Cat: got a highflow item?

Ebc: yes, gizmo are good value.

Air filter: new highflow is $50, check yours.

O2 sensor? Has it been replaced? Dunno if your tuner will touch closed loop anyway.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
    • Ah coolant overflow, previous discussions make way more sense now lol. 
×
×
  • Create New...