Jump to content
SAU Community

Import Monster Sauvic Deca Motorkhana - 2012 Round 1


Recommended Posts

  • Replies 378
  • Created
  • Last Reply

Top Posters In This Topic

I have been up a couple to spectate and take photos. I always loved the skids at the end. What's the go with that? Anyone get to go out as long as there is enough time?

well when everyone has had there goes at the battles and theres no scheduled events left then people get free runs on the pan doing the last battle layout. well ment to anyways

last time i went out and did 2nd gear douies for about a minute and no one got any footage of it at all :down:

but yeah as long as your not out there for too long then its alright, but this is all at the end off the day after everything is done and dusted :thumbsup:

but you do have to be a registered driver

last time i went out and did 2nd gear douies for about a minute and no one got any footage of it at all :down:

If i remember rightly you didnt tell anyone you were going out!

Dont be a sook and just do it again :D

If i remember rightly you didnt tell anyone you were going out!

Dont be a sook and just do it again :D

well i didnt tell anyone i was going to do it yes, but i thought someone would at least have a camera out still :P

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
    • Yeah, I would have said the same. It makes me suggest that there are other things wrong, such that the ECU is totally unhappy with the broken sensor. The only other thought here is that maybe it is shorted, which might cause a different issue to the typical "disconnected" sensor.
    • The fact that US/JDM plates actually fit the skyline bumpers properly is a big, big thing for me as they are the correct dimensions. Annoyingly you can't opt for a normal plate (or plate combination) in that size. You have to make up your own one, and at that point you'd still know it wasn't randomly assigned. 
    • Well, really, that's any ECU, because it's not so much the ECU that the tuner connects to, but a laptop that's connected to the ECU. You have to have the tuning software installed locally. The "remote" part is essentially just remote desktop (RDP) or VNC type access. Nevertheless, if you're looking to upgrade, then you're immediately in the Haltech/Link territory, both of which can be done by any number of competent tuners here in Oz. But without a dyno, you'll definitely also need a wideband O2 sensor fitted, and you'll probably be relying on "auto" tuning a bit, where you drive it around under various loads and then apply the corrections that the ECU learns (basically applying the fuel trims that the ECU has to do to correct the mixtures). Tuning the timing is a little harder. It can be difficult to trust the old OEM knock sensors on RBs, so it is definitely best to have someone who knows what they're listening for, with knock ears (a piezo microphone connected to the engine, and and little amp and headphones so the listener can hear the angry men with hammers who live in the engine). That is more difficult to do remotely, and I suspect the only sane way is to be quite conservative on timing. But that's OK. You're probably waaaaay better off with conservative timing where you are. What is the fuel situation? 98RON available? Or low grade jungle juice?
    • I see your point, I didn't think too deep into it, was purely focused on the price. There's no bad blood between myself and GSM, they acknowledged the price was cheaper else where and at the time couldn't match it. 
×
×
  • Create New...