Jump to content
SAU Community

Recommended Posts

  • Replies 124
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

thats it!. It will be like a Mclaren pitstop lol , It seems fine now, fuel pressures holding, and hasn't missed a beat since cleaning it, so hopefully it will be all good until I get the new pump on monday.

Luke are you meeting everyone at the ettomogah or heading straight to there, I ask because would you be able to bring the pump as a 'just in case" for me?

So Ettomogah Pub meeting point is a go!!!!!!!!!!

See you all there!

Bob.

So.... for those who dont know exactly where Kravings is.

Bells Line richmond

Head towards the mountains

Over the river and through North Richmond

Up the hill and continue to Kurmond

Passed the Restaurant that is all fenced off on the right and its litterally 20 seconds further up on the right.

If your one of the first there there will be my black and grey HR31 GTSX and GregR31's.... R31 which is burgandy and black.

Hope everyone gets there safely and we shall see you there.

So Ettomogah Pub meeting point is a go!!!!!!!!!!

See you all there!

Bob.

Thats where I'm heading to.

Took the car to the mechanic this morning, and he found the TPS and base idle were out of adjustment and a faulty o2 sensor, so he seems to think the pump is ok and it was the ECU going haywire , so I've changed the o2 sensor and it seems ok touch wood.

We will obviously be inside for lunch and in your own cars, possibly with heaters for the cruise lol. I still dont know where we could actually cruise to for some pics or a chat but we can discuss this tomorrow.

19 confirmed and its booked under Liam Ford.... Not Skylines Australia however for those who dont see this I'll word up the Kravings staff that some may say its SAU...

Thanks everyone and see you all tomorrow

We will obviously be inside for lunch and in your own cars, possibly with heaters for the cruise lol. I still dont know where we could actually cruise to for some pics or a chat but we can discuss this tomorrow.

19 confirmed and its booked under Liam Ford.... Not Skylines Australia however for those who dont see this I'll word up the Kravings staff that some may say its SAU...

Thanks everyone and see you all tomorrow

not always obvious on the seating inside.

we thought we would have indoor dining in the pizzas in the mist cruise, that ended up being a COLD lunch....

and liam ford/SAU, same....

Unfortunately lunch is full. It was confirmed on Thursday so no spots left at the table.

Not sure what time we will be finished lunch and going on the cruise, possibly 2pm but depends on how quick we get food and everyone wants to leave. Feel free to come for the cruise tho.

RGB txt me on 0421799454 and ill let you know early morning if I can make the lunch or not, maybe you can take my spot and I come for the cruise.

Had some issues with the car which im hoping to resolve tomorrow morning.

sorry about this being last minute FordyR31, my front bar fell off tonight :(

Edited by extatic

Thank you to everyone that attended it was nice to meet everyone even I have forgotten ur names. Lunch was really nice as I expected and good company to boot. Very friendly and a nice easy cruise and coffee to finish off.

Thanks again and Im glad everyone enjoyed themselves.




  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...