Jump to content
SAU Community

Recommended Posts

Interesting, thanks for the insight Markos!

Well my upper back is definitely feeling it from the deadlifts, so at least I can see it hit my traps etc harder than anything I've been trying to fill the deadlift gap with. Plus my lower back still feels fine :D

  • 2 weeks later...

What are everyone's thoughts on Sumo deadlifts?

My conventional atm is 195 but my sumo is 210 in training. Even though I have shortish arms go figure.

The thing with sumo is it requires a lot more mobility than conventional especially in the hips so many will not try it out for a long period and dont follow through a full training cycle.

Also pulling wide sumo and squatting wide also fries out your hips eventually from what ive seen and experienced.

I have moved in the squat stance and also pull conventional every few weeks to keep the back strong and the hips healthy.

Edited by trentzor

Interesting you say sumo would require more mobility...ironically that's exactly WHY I started doing them - lack of lower back mobility lol.

Also I figured sumo would be better if you've got short arms heh.

Thanks for the input though :D

How sad is it that our 'professional' sportsmen seem to have no idea about simple fitness/strength regimes

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...