Jump to content
SAU Community

Recommended Posts

Hey guys, I'm having issue with my 34 still. I found out the vct solenoid is no longer working and leaking through the plug. Need to know if anyone can confirm a hot start problem with the vct not plugged in. I'm trying to source a solenoid but its proving difficult. fuel consumption is poo, car is hard to start once its warm, and has shocking performance.

Does anyone know if a failed vct would give a hot start prob.

Link to comment
https://www.sau.com.au/forums/topic/408053-r34-gt-vct-solenoid/
Share on other sites

No

VCT doesnt turn on at idle, and AFAIK your startup would not trigger it either.

It's hard to say if the poor performance has anything to do with the solenoid or if you have another problem that is causing all your issues

I don't believe it would screw up your fuel economy. I'm not sure if vct is active at cruise off the top of my head but don't think it would hurt your economy to much if it was on

Someone smarter then me might know more. But off the top of my head i don't think so

I thought vct advanced the timing through certain rev ranges to let more air into the cylinders? Not sure on this but i think i read somewhere it did. So if its not working then it would burn more fuel wouldnt it?

I thought vct advanced the timing through certain rev ranges to let more air into the cylinders? Not sure on this but i think i read somewhere it did. So if its not working then it would burn more fuel wouldnt it?

Advanced Timing doesn't "let more air in" it changes the point in the cycle when the spark plugs fire to burn fuel

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...