Jump to content
SAU Community

Recommended Posts

  • Replies 55
  • Created
  • Last Reply

Top Posters In This Topic

  • 1 month later...

BUMP this up. Sorry for no replys everyone. I was overseas for a month or so. I'll post up an updated list of what is left later on today.

Cheers

Colin

Snorkel is all f**ked up sorry.

Updated list.

94 GTR

Unopened 26
-7 Turbos with actuators 20,000kms old $1000
550cc denso injectors $450
R34 GTR Dumps $250
Front pipe 68mm ID (i think) $350
Catco 3inch cat $100
Fujitsubo catback $150
NPC Organic Clutch pull type. <5000ks old $700
Turbosmart Boost tee $75
Nistune R32 GTR Ecu $300
Yellow Jacket Coilpacks $300
PWR Oil Cooler 22row? and trust oil relocator kit. Will need some hoses. Never fitted to car. $500
GTR Gearbox $500
Walbro fuel pump $100
GTR Seats good condition no tears or rips $600
Rear seats $?? Offer
Full interior available
Suspension available but will need to check what survived
Sumitomo calipers freshly rebuilt $350
RDA slotted fronts and Brakes direct rears brand new with QFM HPX pads $700
HEL Braided lines brand new $120

Diff, transfer case, hubs, axles, tailshaft etc all up for grabs cbf putting a price on it but you get the idea.

Have all of the stock parts for things that have been replaced ie stock suspension, stock turbos, stock injectors, coil packs, exhaust etc.

Full rear cradle, diff etc has been sold aswell.

Edited by Beelzebub89

colin, seatbelts ? all still retract?

door and rear side panels? condition?

can pull all of it when ever you want.

how much of the airbox survived btw?

Only the snorkels got ruined, airbox is still fine. seat belts all good. Panels are we talking door trims or exterior panels? Most of the exterior is stuffed.

Hi just want to know if you would sell the left rear quarter Cut if that's still in good nick ?? cheers

Claude

Quarter cut as in exterior panels? I've got no means of making any cuts that extensive atm sorry.

How old are the injectors?

I'd had them on the car a year or so, bought them second hand. Did 15k kms on them maybe? not even that much I think. No idea how many ks they've done before that, pretty new i think when i bought them.

inside panels. give me a call/ text with a price for the belts,inside panels and airbox. I hav the rest of it already. have money handy.

in regard to panel cuts , i can help there if the buyer needs it. I know where the seams are.

  • 2 weeks later...

Items sold:

Turbos

Dumps

Rear seats

Seat belts

Rear wiring harness

Door cards,

Door rubbers

G sensor

Attessa & hicas control modules

Air box

Indicator stalk

Still lots available.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...