Jump to content
SAU Community

Recommended Posts

sorry man I cant help. But you have the guys who will sort it out

sounds like you may have to re-visit the install of the GB and have another look at the clutch :/

new gearbox or new to you ? State of the clutch ?

After thought, heard a few guys chatting last night. What about electricals/sensors..

New to me, seems fine. I can go through all the gears with no problems as long as I don't hit boost.

The clutch has only done around 10,000km as my mate (same guy) changed it when I installed a new engine.

Prior to this it was working perfectly.

All the sensors were all plugged back in and were in better condition than they were on my old box.

Were the sensors put back in the correct spots.

Are they coloured ? and do they carry different voltage signals ?

I could be totally wrong as seriously I don't know what I'm talking about - lol

just listening to a different conversation...

I think we may have discovered the problem.


On the new box, the front cover shaft was welded back on in the past and we think that the weld isnt allowing the
thrust bearing to go back far enough resulting in the slipping of the clutch (driving like the clutch pedal is half pressed in)

So now I need to try and source the part number to get a new one as the one on my old box has snapped off.

Thanks anyway Richard :)

Trying to keep the bottom list short, but its hard.

"Love the beast" or compulsive modifyer?



Done

big fmic

new kingpin bearings

rb 25 turbo

3" exh w bell dump

one piece tailshaft

podfilter & cold air box

strut braces front and rear

Neomax adjustable coilovers

adj upper arms front and rear

DW tracton rods

Hardrace radius rods

DW hicas eliminator

solid cradle bushes

solid steering bush

oil catch can

thermo fans

Autometer oil, water, fuel/air, boost guages

voltmeter

volt stabilizer

yellow jacket coilpacks

stereo, amp and speakers

new parcel shelf

approved child seat strap mount

rear view camera

sports steering wheel

immobiliser

engine damper

heavy duty clutch

battery in boot

oil cooler and filter relocation w thermostat

removed aircon

Nismo shift knob

electric heater

GTR front bar w n1 vents

Nistune ecu

cam gears

timing belt

water pump

rear wiper delete



To Do

fix harmonic balance

tap temp switch hole

fix intercooler piping

fix immobiliser light bezel

fix pod & cold air box

radiator and oil cooler ducting

braided brake & clutch lines

fire extinguisher

fuel pump

injectors

z32 afm

tune


pwr steering cooler

improve head lights

boxes in boot

heatsheilds

dash

fuel cooler

diff centre?

good thermofan

drivers seat

use stickers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Cheers. Skyline is back on the menu, can’t get rid of it. It’s like a child you don’t want, or herpes 
    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
×
×
  • Create New...