Jump to content
SAU Community

Recommended Posts

Anyone have one working nismo afm i could borrow to diagnose mine?

What is the problem? If you are running a PFC you could see the sensor input page and see the volts going into the PFC. You should be able to compare the both.

Yup, you can select whatever you want to be displayed from the remote. For me boost (and oil temp) will be displayed as 2 readouts on the digital screen. I figured big analog oil pressure was more important than boost. :)

That's pretty awesome, how much dosh?

They were roughly $500 delivered when i last looked.

Also read scandys S14 build thread on JDMST tonight as well. You love pulling it to pieces don't you?

Less than that. :)

Hahaha, yeah, it's something I do an awful lot, and then stop not long after.

Less than that. :)

Hahaha, yeah, it's something I do an awful lot, and then stop not long after.

Really? Pm where from was looking at them before however they were either expensive or had a long wait on them.

I have done the same recently too, but i dont know what im doing with it yet.

  • Like 1
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...