Jump to content
SAU Community

Recommended Posts

Yeah a guy at work said I should call the NRMA to check with a multimeter for me. I managed to get to work with a jump pack (didn't work straight away though, took a few goes) so I'll see how it goes when I try to get home lol

What happened originally is that I used the high beam and the car went into limp mode (yes, warning lights on the dash, like when the coil packs go)... no power at all, even the stereo cut out. Got home, car only JUST started the next day, and then wouldn't start after work but a jump start got it going.

That was last week and it's been fine all week (I haven't touched the high beams, been too scared). Then today..... nothing :(

Thread defs should be a sticky where people can post up their issues and we can all get together to try and help

What do you think shell?

This thread is too long and I skip posts. Just let me know if you want me to have a look :).

Eiji and Zeb, that would be great if you have time.... tomorrow after work, or some time on the weekend?

Happy to sticky the thread if you guys want.... I'm bad with stickies though, I tend to ignore them LOL

Very unlikley to be low comp after you do a hot test, but in saying that my drift car had almost no comp and we only found that out when decklan from garage 7 put a new clutch in, it was so low you could blow on the flywheel and it spin lol.....nah but you could turn the engine over with a finger and the bastard still made 280rwkw. Then to top things off the engine sounded perfect however when I pulled the sump off to have a look in there a whole bearing was in the bottom of the sump.....WTF LOL, still ran great and did some stinky skids.

Whatever suits you best shell. Weekend is probably better because daylight

Yeah true... I have no plans, so any time except morning haha. I might just check if my dad has one first, cos I'm going to try to visit him this arvo.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...