Jump to content
SAU Community

Recommended Posts

Hi all,

Just bought my brothers r33 gtst which is hunting whilst driving or idle..

It was blowing some black smoke which has stopped since replacing the fuel filter, spark plugs and oil filter/oil.

At the same time the hunting stopped so i thought i had fixed it however today it started again....

I am sus to it being the coil packs ?? (does this sound like a possibility?)

didnt want to pointlessly buy some so was wondering if anyone in Penrith/western sydney has any i could try and see if they fixed the problem?

Link to comment
https://www.sau.com.au/forums/topic/430698-r33-gtst-hunting/
Share on other sites

Hunting during idle is typically due to additional air getting into the system which the air flow meter isn't registering. This is due to a leak somewhere.

The most likely culprit is the black charcoal box that they have to install when importing for emissions reasons. One of the hoses that comes out of this feeds back into your plenum. If you plug the hose with a ball bearing and the hunting stops you've found your culprit. Other points to check are the multitude of vacuum hoses that run around the engine but you don't often see these leaking.

  • 2 months later...

OK guys, reviving a bit of an old post, still having issues...

symptoms:

Car is hunting (not always) on idle...

when driving there is a miss (sometimes not consistent)...

when driving revs cut out completely but the boost gauge on the dash says its still on boost (do not need to be driving hard - intermittent)...

Fix Attempts:

Cleaned the AFM

Cleaned the AAC Valve

Changed Spark Plugs

Changed Fuel Filter

Changed Oil Filter

Changed cracked vacuum hose coming off of the plenum (just above the aac - went back to a black box)

Plugged above hose after changing it didnt help

New genuine o2 sensor

I'm out of ideas, the only thing i have yet to try would be coil packs but dont want to spend all that money and it not be the problem. any other suggestions?

OK guys, reviving a bit of an old post, still having issues...

symptoms:

Car is hunting (not always) on idle...

when driving there is a miss (sometimes not consistent)...

when driving revs cut out completely but the boost gauge on the dash says its still on boost (do not need to be driving hard - intermittent)...

Fix Attempts:

Cleaned the AFM

Cleaned the AAC Valve

Changed Spark Plugs

Changed Fuel Filter

Changed Oil Filter

Changed cracked vacuum hose coming off of the plenum (just above the aac - went back to a black box)

Plugged above hose after changing it didnt help

New genuine o2 sensor

I'm out of ideas, the only thing i have yet to try would be coil packs but dont want to spend all that money and it not be the problem. any other suggestions?

The miss could be caused by the coils, but I am not sure if it is causing the hunting. If the car has done well over 100k kms, the coils should be changed anyway. A set of splitfires set me back $400 and were easy to install, and should last you another 100k kms and will last with any mods you plan on doing.

Like Plattsy said, try a ecu reset. Although I didn't think it needed to be off for 24 hours, I would have thought 20 mins would be enough.

The miss could be caused by the coils, but I am not sure if it is causing the hunting. If the car has done well over 100k kms, the coils should be changed anyway. A set of splitfires set me back $400 and were easy to install, and should last you another 100k kms and will last with any mods you plan on doing.

Like Plattsy said, try a ecu reset. Although I didn't think it needed to be off for 24 hours, I would have thought 20 mins would be enough.

you can do it in twenty if you pump the brakes or some shit. but i always left it for a day to be sure.

Tried the ECU now, no good still the same. the annoying this is its not consistent, at first it ran well but shortly after started having the same issues. Any other ideas? I was thinking due to it being intermittent it might be some sensor or electrical fault?

OK, car ran good for about a week, played up again, ran good another 2 days, played up and now seems to have a constant issue of the car starting to drop revs when i go above 2500 RPMs in any gear. If i stay below the 2500 the car is running fine.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Resizing injectors in Nistune can be done a couple of ways, and there are a couple of ways that you can make a mess of it. The tuner needs to be really aware of the effects of whichever approach he uses (either K, or TIM). They are both easy enough to "get the injector size right" to run the engine. But little details like old start enrichment and hot start are affected differently, depending on which boxes you check.
    • Pretty safe to say almost everyone that has tuned their own car has experienced this issue. The difference being that we have our laptop in the car and when it happens, it's literally 10 seconds of tuning to sort it.  Would you be happy to plug in your laptop and sort this yourself? It is a very simple process and there is no risk of harming your engine (if you are worried about that). 
    • Yeah thats the next step now, either they wil or i will take out for a drive to work and go straight their after work and see is we get the same issues 🤞  thought i try my luck here too, never know someone else might have had the same issue but thanks for the reply 
    • Basically your tuner needs to drive it for the 30 min (or whatever) to create the same conditions then check the ECU settings and sensors at that time. They may not be excited to because that takes them 30 min rather than just opening the bonnet and seeing the problem straight away.... Hot start is generally not as tricky as cold start, but there would be a table for fuel enrichment vs coolant temp as a starting point
    • Yeah, they all cant say anything for sure as everything is working fine . Said unable to find an issue untill it stops again. Could mist likely be CAS wiring or IAS valve issue but again not 100%
×
×
  • Create New...