Jump to content
SAU Community

Recommended Posts

SAU GT6 SUPER-LAP

Vehicle Regulations:

- The car must have originated from a stock Japanese production car, no Racing cars allowed (SuperGT,MINES,HKS ect.)

- Any kind of performance tuning is allowed (apart from tires and Nitrous).

- Nitrous (NOS) is NOT permitted.
- Tires used must be street legal, max tire is Sports Soft (S3).

Track:

Mount Panorama

Event Regulations:

- Lap must be done in Arcade Mode Time Trial.

- Fastest lap must be clean with a maximum of 2 wheels coming off the track at any one time. Run off areas such as on the main straight and hairpins count as part of the track.

- Save fastest lap replay.

-If your time beats the record then you can submit the replay. (If it's not to much trouble)

Safety Rules (Optional)

  1. Helmets complying with a minimum AS1698 or as per the requirements of the organisers of the event. Must be in good condition without any perforations to the outer surface.

  2. Footwear, socks and gloves made from flame retardant material complying with FIA 8856-2000.

  3. Anyone playing outside , goggles or a visor with a lens material other than glass (ie to AS1609-1981) are mandatory.

- Submit:
Fastest Lap Time:
Name:
Car Used:






Link to comment
https://www.sau.com.au/forums/topic/437515-sau-gt6-mt-panorama-super-lap/
Share on other sites

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Ok, well I might as well be the first to post a time.

Time: 2:03:599

Name: Mad-082

Car: r35 gtr black edition '12

Mods: everything (but no running to suspension, etc)

Shouldn't be too hard to beat, since I crossed the line backwards in a cloud of smoke after a massive tank slapper, lol. And I had a big moment coming into the cutting where I lost a few car lengths on my previous best time

Fastest Lap Time: 2:02.025

Name: hrd-hr30

Car Used: R34 GTR V-spec II

That's a good lap. I was stuffing around and did a few laps in my r34 n1 and I only did a mid 2:05. It was a sloppy lap, but not sure that I'd get over 3 seconds more out of it, at least not without playing around with the tuning

You buy me one, as well as a house big enough to allow me to set it up and I'll use it.

You can get steering wheels cheap, and you don't need a big house I sure don't have one. You just have to get creative

Good to see some times going up, hopefully I can get on this weekend.

You can get steering wheels cheap, and you don't need a big house I sure don't have one. You just have to get creative

Good to see some times going up, hopefully I can get on this weekend.

I live in a 2 car garage and play the ps3 on my bed......

But anyway, I discovered that I hadn't changed the oil on the cars I was having a go with, so I did that, gained some horsepower then had another go.

Car: r35 gtr black edition '12 (same as earlier)

Name: Mad-082

Time: 1:58.560

Pretty happy with that, but reckon I might be able to crack into the 1:57s if I sat down for longer and really had a proper go and played with the tuning of the car. Also got my r34 (well different r34 to the one I used before) into the 2:02s with a few mistakes.

Nice times Marc, yeah I used to live in the garage many years ago when I still lived at home. It was awesome for awhile but the f**king Mosquitos would find their way in! There's quite a few simulators that fold up and can be stored in small spaces. Or just bung some hooks in the roof and put it up there :) it's all about gran tourism and you gotta get creative. You can notice the difference in the handling of cars and get a better feel for the game with a steering wheel. Anyway the more ppl who join us the better, steering wheel or not..

If someone can edit the leaderboard that would be awesome.

Time: 2:02:120
Name: dyl33
Car: R33 GTR v-spec

Steering: Wheel G27

1:58's pretty fast mad082. I reckon I can get in the 1:59's with some tunning. Got to sort the suspension out.


Edited by dyl33

Yeah 1:58 is fast. I don't think I could get below 2:00 in an earlier gtr than the r35. The 35 is a totally different car (the 34 is more fun though). It's more stable across the top of the mountain, (although it understeers more coming down the mountain) and the fact that it has about 300hp more power (although it's also heavier). I'll have a go with some different cars tonight if I get a chance. I'll try a lancer, etc.

Tine - 1:58.452

Name - Nismon1

Car - R35 12 Black Edition

I think there's def a 1:57 in it, as out braked myself and ran wide on a fair few corners.

35 is fast, but for fun, gab a MP4-12c, tune it with everything and give that a rap around Bathurst. Awesome car, but hard to tame and can only do a 2:01 in it

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Next, remove the upper and lower radiator hoses, both are held with a spring clamp. While you are under there, tackle the Auto Trans cooler lines.  Again both are held on with spring clamps, and as mentioned above you should cap them on the radiator side with an 8mm cap, and on the car side loop them with a length of 8mm pipe - this will stop you losing a dangerous amount of AT fluid during the rest of the job If you've been meaning to add a sender for AT trans temp, this is a great time to do it; put a sender fitting into the passenger side line as that is the inlet to the cooler/radiator.
    • Next you need to remove the intake duct (as with pretty much every job on these cars), it is a series of clips you gently remove with a flat bladed screwdriver. They do get brittle with time and can break, and I have not found a decent quality aftermarket one that fits (they are all too soft or flimsy and don't last either) but the nissan ones are a couple of bucks each (ouch).  Once the clips are off (either 8 or 10, I didn't check) you lift the intake duct out and will see the reservoirs Undo the line into the radiator side cap (some bent needle nosed piers are awesome for spring clamps) and then remove the 4x 10m nuts that hold both in place.  I didn't get these pics, but remove the line under the radiator reservoir (spring clamp again) then remove that reservoir. Then you can get at the intake reservoir, same thing, spring clamp underneath then remove it. BTW This is a great time to put in a larger (+70%) combined reservoir that AMS makes..... https://www.amsperformance.com/product/q50-q60-red-alpha-coolant-expansion-tank/ They also make an Infiniti branded and part# version if that is your thing
    • To drain the Intake Heat Exchanger, there is a crappy drain plug in front of the driver's side front tyre: You should use the largest headed phillips screwdriver you had, and in my case I needed vice grips on the hose above as the plug was tight (tighter than it needed to be, since it has an o-ring seal).  After you have a tray down and open the drain, open the intake heat exchanger reservoir cap (drivers side one) and you should get a couple of litres of coolant To get to the radiator, you need to remove the plastic engine undertray. It is held on with a series of 10mm headed bolts and some clips. For the radiator, there is another type of crappy drain (kind of like a plastic banjo bolt) and you should attach a length of hose to direct the stream of coolant per this pic (otherwise the coolant hits the rad support and goes everywhere). The drain is on the rear of the radiator on the driver's side and a bit hard to find. Put a big tray or bucket down (5l won't be enough) and slowly unscrew the fitting by hand. You only want to remove it far enough for coolant to flow, it you unscrew it right out the whole fitting and direction pipe will come off and you will get a coolant bath (yum!). Undo the radiator reservoir cap and it should empty about 8l
    • So, this shouldn't be such a mission, but there were a few tricks so I thought I'd post up a DIY for it. This was on a Q50 Red Sport but I doubt any other V37 model is very different (maybe just less steps for the intake heat exchanger hoses) I pulled the radiator out to flush it because the car was running hot at the track, but obviously the same steps apply for changing a radiator for any reason including an upgrade. If you are removing the radiator, you of course need to drain and refill, so have 5+ litres of blue coolant ready. You also need to drain the intake heat exchanger to remove the radiator so you will need a couple of litres for that as well. You will also need something to deal with the auto transmission lines, I used 2x 8mm rubber caps on the radiator side, and a short length of 8mm pipe on the car side.....unless you can block these lines quickly you will loose AT fluid and it may be enough to hurt the transmission if you don't refill it. 2 other tools that really help dealing with coolant lines and spring clamps are Bent Needle Nose pliers Hose pliers Between them they will reduce the frustration (and injury) potential by about 1000% Other than that....lets go... "First, jack up your car". Yes really, and put it safely on stands. If you are not confident doing that you need to give this job to a mechanic
    • If the forester is anything like our old 2007 GTB Liberty, I could near on run ling Long's and "rate them", as no matter what, it just hung to the road, even when abusing it in a hard launch in the wet, or throwing it at corners.
×
×
  • Create New...