Jump to content
SAU Community

Recommended Posts

Hi all. Today while driving normally on my way home my 'VDC off' , 'Slip' and the park brake light all came on on the dash. I pressed the VDC button a few times and no change.

I stopped the car turned off and on again and it went away. Then drove off and about 200m later they all came back on again. I left it as I was now on the motoray then the handbrake light went off. I stopped at the shop turned off went into the shop and them came out and started it again. Everything seemed find for the next 5k's home. On the way I tested the VDC on off and it was working. ie. when off the wheels spun when on they didn't.

Does anyone have any ideas what might cause this?

Is the handbrake related?

A few weeks ago I adjusted the hand brake and since then the hand brake light pops on sometimes after hard acceleration then goes off. But this VDC thing is new.

Link to comment
https://www.sau.com.au/forums/topic/441452-vdc-turning-off/
Share on other sites

There's enough brake fluid in the system that as the pads wear it doesn't need topping up . If you top it up you have to sick it out when replacing pads.

So if the fluid is low, it has lost some somehow or the pads are totally screwed.

Link to comment
https://www.sau.com.au/forums/topic/441452-vdc-turning-off/#findComment-7248637
Share on other sites

This can be a symptom of several different faults. I had a bad connector on the throttle pedal connector which gave the same warning lights and also severely limited power until I shut down the engine and restarted.

You need to get the codes read to determine the actual cause.

Link to comment
https://www.sau.com.au/forums/topic/441452-vdc-turning-off/#findComment-7248693
Share on other sites

This can be a symptom of several different faults. I had a bad connector on the throttle pedal connector which gave the same warning lights and also severely limited power until I shut down the engine and restarted.

You need to get the codes read to determine the actual cause.

can you direct me to where or how I can read the codes?

Link to comment
https://www.sau.com.au/forums/topic/441452-vdc-turning-off/#findComment-7250048
Share on other sites

A Nissan dealer or someone with a Consult3, some good mechanics may have a OBD3 reader which should be enough to check for error codes.

I will never want to take my car to Nissan, I've never had good dealings with car dealership workshops with any of my cars. Dealers are hopeless. Any one know any good workshops in brissy that can do a code check?

Link to comment
https://www.sau.com.au/forums/topic/441452-vdc-turning-off/#findComment-7250187
Share on other sites

Try East Coast Customs at Geebung, I know they have all the gear to find the issue (and fix it).

I have had the VDC - Slip light issue many times. So many things can cause it, last time it was my steering wheel column slightly out of alignment, previously it was another sensor. If the code represents something that is not too bad (such as steering wheel column out of alignment), it seems to just turn on the slip and VDC off lights and just disables that system but the car drives normally. If it is a little more severe such as throttle sensor having a glitch or if the pedal position sensor is having a moment, the engine light plus the slip and VDC off lamps all come on and then the car goes into limp mode. This goes away sometimes if the car is turned on and off again. The park brake light might be the clue, I havn't seen that on at the same time as all the other lights.

Personally I have an Uprev flashed ROM on mine so I can plug in my laptop and see straight away what the issues are and clear the codes to temporarily fix the problem.

Link to comment
https://www.sau.com.au/forums/topic/441452-vdc-turning-off/#findComment-7250473
Share on other sites

Try East Coast Customs at Geebung, I know they have all the gear to find the issue (and fix it).

I have had the VDC - Slip light issue many times. So many things can cause it, last time it was my steering wheel column slightly out of alignment, previously it was another sensor. If the code represents something that is not too bad (such as steering wheel column out of alignment), it seems to just turn on the slip and VDC off lights and just disables that system but the car drives normally. If it is a little more severe such as throttle sensor having a glitch or if the pedal position sensor is having a moment, the engine light plus the slip and VDC off lamps all come on and then the car goes into limp mode. This goes away sometimes if the car is turned on and off again. The park brake light might be the clue, I havn't seen that on at the same time as all the other lights.

Personally I have an Uprev flashed ROM on mine so I can plug in my laptop and see straight away what the issues are and clear the codes to temporarily fix the problem.

I backed off the adjusting nut on the foot brake pedal about half a turn and havn't had the problem since. I think maybe I over adjusted it to trigger the PB light and perhaps that led to the VDC.

Link to comment
https://www.sau.com.au/forums/topic/441452-vdc-turning-off/#findComment-7254785
Share on other sites

I doubt a park brake light would cause a VDC system error.

I would still keep an eye on it.

well the VDC has not come on since, However there is a hill just before I get home (driving up) and frequently as I accelerate up the hill (>50% WOT) the hand brake light comes on, then as I back off the throttle it goes off again. If I drive up more moderatley it doesn't come on at all. So weird.

Link to comment
https://www.sau.com.au/forums/topic/441452-vdc-turning-off/#findComment-7256548
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Welcome to my 2004 Toyota Mark ii IR-V Fortuna (series 2) With a 1JZ-GTE powerplant under the bonnet (hood) it'll give me plenty of scope for power upgrades. For those who aren't familiar with imports, the 1JZ-GTE is a 2.5L 6 cylinder VVTi engine with a single turbocharger. This has the factory R154 5 speed gearbox, along with a aftermarket 2 way LSD differential (brand unknown). Under the arches are a set of CST Zero 1 alloys, 18x9 +30 225/40 up front and 18x9.5 +15 265/35 on the rear. The car was quite low in Japan and there's evidence of the wheels catching the rolled arches/fenders. The tyre's aren't great so I'm in two minds whether to replace both or just the tyres and put up with the wider wheels on the rear. The car still uses stock brakes with the addition of some braided hoses. The exterior is stock with the exception of a BN Sports front bumper and a replacement Fortuna grill  Moving to the interior, the steering wheel has been replaced with a dished MOMO steering wheel (which will get swapped for my Momo Tuner for the time being) Defi Link Gauges are mounted above the climate controls and on the A pillar, the Oil Temp,Oil Pressure,Water Temp and Boost gauges should help with spirited and track driving  The stock seats have been replaced with some retrimmed Recaro bucket seats. Being a larger build these are a little snug, unfortunately the orange isn't for me so I'll look into replacing these down the line. Other modifications include a twin plate clutch, Blitz intercooler, Evolve alloy radiator, a stainless exhaust with decat, HKS EVC-S boost controller and coil overs
    • Apologies for the long read My R34 GTT was up for sale at the beginning of spring due to a few repairs creeping up. The strut tops needed replacing, roof and bonnet (hood) painting (yay for 3 stage pearl) and the underside stripped and treated. I sold the car which allowed me to be in a much better place financially. Leading up to the sale I was already thinking about the replacement. In an ideal world it needed to be a good all-rounder. Something I can mess around with, modify, do track days, do the school run, go on long drives etc.  Options included but not limited to... Laurel C35, Evo 8/9, Civic FD2, Impreza Hawkeye, Aristo and even an Audi S4 Avant (I've already got the Mazda 6 wagon). But there was always one car at the top of the list The Toyota Mark ii JZX110 I found an advert on a Facebook group for an example in Japan, from a seller called Jon at Rising Sun Exports. A few messages back and forth and Jon calls me from Yokohama one morning (or afternoon in his case). He briefly explained the import process, the costs involved and a repeat of the advert. After much deliberation, the price was agreed and the sale was locked in. I've never imported a vehicle so I jumped into the unknown head first. The money transfer was completed through wise.com (fees apply), very easy to use and the money was with him within a day or two.  The car suspension was raised for the vessel and the car dropped off at the port. It was 7 weeks later when the bill of lading was received and the freight invoice sent to me, followed by the export certificate a couple of days after (both digital copies) In the mean time the port had been in contact. I needed an agent to deal with the NOVA (notification of vehicle arrival) along with the tax/duty invoice, this was £75.00. The port also had a fee of £100, I'm guessing to cover the cost of the 10 day 'free storage' and for moving the car off the boat etc. They need a copy of the vehicle invoice, freight invoice and export certificate to allow the vehicle to pass through customs. The vessel arrived on Tuesday 5th August, the tax/duty invoice was generated and sent over. This is generally tax 20% and duty 10% of the vehicle value. Although the invoice came in at a higher amount than I had calculated. Once HMRC had received the payment the vehicle could be released from customs. I thought once the tax/duty was paid you could collect at any point, that's not the case. Your agent will need to book a collection slot, I requested Thursday 7th which was accepted, with a 9:00am slot allocated. It was a 5:00am start from Norfolk heading to Southampton. We eventually found the compound, upon presenting the bill of lading and some ID they released the car (they drove it out of the compound to the front ready for us to load up). The email from the port stated each slot had a 10 minute window, which seemed abit farfetched but the staff said it's not a strict rule. We were there for approx. 30-40 mins in total. A week prior to collecting I contacted my garage and explained the situation, I was able to get an inspection slot that afternoon. For the registration, DVLA require the car to be insured, for this I used a company called Adrian Flux who can insure the vehicle using the VIN number. 
    • Hey guys, looking for these side skirts if anyone can help me out. 
    • Wife and I are still looking for a new home. One condition was a large enough garage for a full-size lift in one bay. Now if only we could find something... We've been looking for almost a year now.
    • Thanks everyone for the ideas! Sadly, ramps are a no go for me. With young kids at home, I do most of my work late at night while they're sleeping. Starting the car multiple times wouldn't be a great idea.  I'll go see one of those new long reach low profile jacks and take a couple measurements to see if they will fit.   
×
×
  • Create New...