Jump to content
SAU Community

Rexmas 29Th Nov - Sandown (Cams Come And Try Event)


Recommended Posts

I know quite a few of you have attended and raced at several joint SAU and WRX club events. So i thought id post this here to extend the invite to the SAU community to attend and have a great day out.

Event details can be found at the following link: http://www.wrx.com.au/event-1773863

FYI - this is also a "come and try" event for those people who havent had there car on a track before, CAMS are offering come and try licences for $25 on the day for anyone wanting to get out and have some fun.

Hope to see you there :)

Kristian

  • Like 1

A fair few of us regulars from this year are all off to a wedding.

Was looking forward to it as well until we realised the clash. I even debated coming down for a few hours beforehand for some fun haha :D

It'll be a good day, people should get on it.

Yeah what Ash said, I would have come if not for a wedding.

Did Rexmas 2 years ago, was a fun day and a lot more relaxed with passengers allowed and no timing than the usual sprint days.

There still spots? I though it sold out in a day. I know it was half full when I applied that arvo. Either way it's $180 for non WRX members like us.

See you all there, should be a great day in the new track hack Taxi. :P

There still spots? I though it sold out in a day. I know it was half full when I applied that arvo.

The "Entries" figure for Rexmas includes guests, not just drivers, so they know numbers for food etc

Guest
This topic is now closed to further replies.


  • Latest Posts

    • I think he was only proposing to use the wire, not the sender. Simply because it runs from the right place to the right place. Personally, I wouldn't hack up the factory wiring like that. I'd just lay in the Defi loom.
    • From memory it wasn't too hard to simply see which wire ran where when you plug that in. Unfortunately also from memory the OEM sender does not use the same configuration 99.9% of gauges run. So in other words if you connect the signal wire that was running to the OEM gauge to your DEFI gauge you might find your oil reads at 200C or some other incorrect value. I remember having the same line of thought and then running new wires/senders to match the gauges I have. The pinout is available in the R34 workshop manual.
    • Does anyone on here know which wire on the GTT triple gauge pod harness is for the oil temp gauge? my sensor works fine but I upgraded the gauges to DEFI advance. And if I can simply piggyback off the oem oil temp wire to the Defi oil temp sensor wire that would make life so much easier. 
    • Even face her a wash now that’s it worth more than my house
    • This was what I was invisioning, or Pete cutting a beer can up and hose clamping it around the catch can! Ha ha ha
×
×
  • Create New...