R32 Gtr Clutch Pedal Adjustment Help

[SiR_RB]

I need to "raise" my clutch grab point as it's way too low

I need a definitive answer as to which way to turn the clutch adjustment screw to lift the pedal,

Clockwise, so into the master cylinder? or anti clockwise and away from the master cylinder?

Thanks

[XKLABA]

bottom towards passages side, that would be clockwise on your description

[GTRPSI]

bottom towards passages side

Or in other words, make the rod longer, your lengthening the rod or screwing it out of the pedal assembly.

Edited December 21, 2014 by GTRPSI

[XKLABA]

Yep, exactly

[SiR_RB]

Screw it out of the pedal assembly

Got it, thanks

[jiffo]

You must still have free travel so don't go overboard.

You didn't say whether this has suddenly happened or if it's a low pedal following a clutch replacement or such.

If it's a recent event, you should be looking to master cylinder.

[SiR_RB]

It's was perfect then I had issues with the grab point and getting It into gear, so I adjusted the pedal adjustment, I had a slow leak which became so bad the car left me cos I couldn't get it into gear, the stock rubber hose coming off the slave was pissing fluid

So now I need to re adjust it again

[XKLABA]

When you put the Nismo clutch hose on properly you then have to adjust the clutch pedal hieght

[GTRPSI]

Make sure you bled the system first before adjusting anything if you had a leak and fixed it.

[SiR_RB]

Everything is bled and running great will just adjust the pedal rod to make the bite point higher

Thanks

[djvoodoo]

Thread revival. Anyone have any tips for undoing the 12mm nut when it's been rounded off? 

I can't get much leverage to hit the nut from another hex side that is ok. I've tried some thin vice grips but the nut is too rounded.

Will try a flare nut spanner when i get to Repco/ Bunnings etc but seeing if anyone has any tricks/ home made tools?

[GTSBoy]

Mig spanner.

[niZmO_Man]

On 03/11/2021 at 11:08 PM, GTSBoy said:

Mig spanner.

The one with vacuum tubes?