Jump to content
SAU Community

Recommended Posts

the championship is fixed setup, but practice by yourself you can tune them. but its pretty counter-productive if you have to go back to fixed setup when racing.

Most of the "novelty" cars you cant much beyond tyre pressure and camber. The Jetta is an example. FWD FTW. would have come first last night by like 30secs if i had that beast :P

Yeh I adjusted brake bias in practice, then checked settings in the actual race and couldn't touch it all fixed

I saw you spin out at like the turn 4 hairpin did lol :P

Game is pre hard to get used to, definitely cant just throw it around like forza

Edited by UNR33L
  • 2 weeks later...

The spec racer ford has a tonne of lift off oversteer. You correct it by getting very slightly on the throttle when you suspect the rear's going to get loose.

Basically to get the most out of it, the way to go is either left foot braking + a smidge of accelerator, or just wuss out and brake in a straight line, heh

  • 2 weeks later...

I presume were running the Summit Point Raceway configuration for tonights round?

thats right, summit point. Unless stated otherwise consider it full track config each round :)

An hour till practice! Think I'll be needing this extra hour to practice as well!!! Hope to see a few of you on track tonight, summit point is a great track and the racing should be fun!!! See you there from 8pm :)

So another round over and done with, and what a race it was! After 20 laps I was exhausted!!!

Anyways here are the results from the race -

11334157_10154031025974386_2476048245063

Prac and Qualifying -

11334022_10154031025969386_7357860748882

And here are the standings for the season thus far -

11407138_10154031025944386_6070696805610

Thanks a heap for a great race everyone, was more than fun!!! See you all next month for Round 7 :)

  • Like 1



  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...