Jump to content
SAU Community

Recommended Posts

9 hours ago, t_revz said:

 


I’ve forgotten how much damage there was?

Reo bar, front bar and headlight? Or worse than that?

 

Radiator suport, right headlight skirt, intercooler, bonnet and a few other panel parts. It basicly needs a whole front end

1 hour ago, Beyond Blue R33 said:
On 18/11/2017 at 6:48 PM, R33kizza said:
1893..... 

Would be a few tuppence or sixpence in 1893. A old tinny loading it with a heavy lead based solder.

I wish, thats dollars with a 500 excess it drops to 1500 with 1k excess

I wish, thats dollars with a 500 excess it drops to 1500 with 1k excess


Wait... that’s the insurance premium?

I thought you were asking for a guess on a quote to get the car fixed. 1893 seemed reasonable.

1893 PA for insurance on a relatively cheap car is ludicrous.
2 hours ago, t_revz said:

Morning all. Last day off and can’t decide what to do... feels like a good day to watch movies and drink beer haha emoji481.png

Drink rum and have a wank

  • Like 3
18 minutes ago, Stinky Rooster said:

Damn my neck hurts

 

turns out spending a quiet evening licking bourbon bbq sauce off ones own nipples can have unforseen consequences :(

Well shiiiiiet.

Hank slept well, had to try hard to get him up this morning.

  • Like 1
Damn my neck hurts
 
turns out spending a quiet evening licking bourbon bbq sauce off ones own nipples can have unforseen consequences [emoji20]

who would have thought that your neck just wasn't made to do that sort of thing.
  • Like 1



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...