Jump to content
SAU Community

Recommended Posts






Ok... I'm hoping that's not me. My surgeon suggested I'll be able to get back on my bike within a week. Maybe I'll just push that back. Regarding underwear (sorry to lower the tone all), are normal briefs/y cuts ok or should i be getting something else?


I bought jocks that were 2 sizes too small and the surgeon told me they weren’t small enough and didn’t hold my waist tight enough . Bought small briefs that have worked well





Ok... I'm hoping that's not me. My surgeon suggested I'll be able to get back on my bike within a week. Maybe I'll just push that back. Regarding underwear (sorry to lower the tone all), are normal briefs/y cuts ok or should i be getting something else?


I bought jocks that were 2 sizes too small and the surgeon told me they weren’t small enough and didn’t hold my waist tight enough . Bought small briefs that have worked well
  • Like 2
And 3.5km of traffic jam because of a crash. Fun on the skyline clutch. Oh and a crash this morning that was a 15 Min of traffic jam. [emoji34][emoji35]


Aren’t skylines allowed to use the emergency strip to pass everyone?

Pretty sure you have to do a skid for the privilege
  • Like 1
Plenty of my mates recovered within 48 hours. But a guy I work with suffered badly too.


Your body is just protesting your decision to eliminate it's ability to produce further loin spawn.

Hopefully it comes to accept what's done is done and it stops this protest swelling business.
  • Like 1


Aren’t skylines allowed to use the emergency strip to pass everyone?

Pretty sure you have to do a skid for the privilege
Yeah, I was highly tempted to give it a go but managed to reign in all the irrational thoughts that come naturally with red hair.... And being stuck in a traffic jam.
  • Like 1


Your body is just protesting your decision to eliminate it's ability to produce further loin spawn.

Hopefully it comes to accept what's done is done and it stops this protest swelling business.


Still would have been less painful to have another kid.

  • Like 2
Yeah, I was highly tempted to give it a go but managed to reign in all the irrational thoughts that come naturally with red hair.... And being stuck in a traffic jam.


Wise beyond your years
  • Like 1


Should have had your ice skates on.

Did they take anything ?


Yeah, Hema, UHF, Oakley prescription sunnies, drone charger and an asthma puffer cops came in about 5 mins and she was arrested within 10 it was insane how it all lined up so well
Did you get everything back?

Don’t forget the 10 laptops and flat screens on the back seat they took


Lol only claimed what she took, she actually ditched it all next door so we got it back but it was all f**ked scratched or cracked



  • Similar Content

  • Latest Posts

    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
    • For race cars, this is one part where I find having the roll cage bar having gone through a hole in the floor better than the build it up on a ledge inside... The Merc I help on, the main hoop ends are marked on the car, and the jack is marked... Jack goes under a few inches and lifts one whole side of the car up... Removes that fight for long slim jacks for race car duties!   My biggest issue for the daily drivers I work on, is my jacks don't go high enough. The jacks start out on a few blocks, jack it up, then start a second jack under it on more blocks, and then I can get an axle stand under it. My axle stands are presently in use, and are nearly fully extended. The car is sitting with barely more than a cm of clearance to get the wheel off the studs! Sarah's Kluger is the same, as it has an ungodly amount of droop available in the suspension and a distinct lack of good jacking points!
    • Happy? Yep, my to do list is getting shorter and shorter. Either this light approaching is the end of the tunnel, or I'm about to be hit by a train... Ha ha ha   Also, Duncan isn't that far out of town that you need to make a multi day drive out of it. 😛
    • Sorry I meant that we are building the EH for a client.
    • LOL, when one "money pit" is never enough Noice, and excellent work mate
×
×
  • Create New...