Jump to content
SAU Community

Recommended Posts

I'm looking for a very clean example of an R32 GTR. I am in contact with import agents in Japan but am also looking within Australia to potentially save time/money.

The car needs to be as standard as possible (interior/exterior) and the lower the kms the better.

I am willing to travel interstate if you have the right vehicle. I am located in Melbourne.

Thanks for your help!

Link to comment
https://www.sau.com.au/forums/topic/459962-wtb-immaculate-r32-gtr/
Share on other sites

I've seen that one, unfortunately it is out of my budget.... its seems the owner has a premium on it due to it being a Nismo edition.

And the fact that it's done 16,500 kms....... I've inspected the car and the mileage is genuine.

Bob.

  • Like 1

And the fact that it's done 16,500 kms....... I've inspected the car and the mileage is genuine.

Bob.

I have no doubt the car is amazing... but a bit too pricey for me.

The market is slow, even in Japan. I guess I'll just have to keep waiting

What's your budget

Depends on the quality of the car and specs. Normal GTR vs V-spec etc. Dont particularly want to spend more than 35-40k but in saying that I may spend up to 50k for the right car.

I bought my BCNR33 from Global Auto - as well as the AutoSelect 34GTR - dont expect a bargain - but you will find some amazing cars.

Nothing rings more true in the saying "You get what you pay for" when talking GTR.

Dan

Check out global auto in Japan

They stock some of the finest gtrs, prices have gone up so be prepared to pay upwards of 2'500'000yen plus to bring it here

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
    • You think its the AFM? I know its a common issues on R32s. I find it coincidental how this issue raised right after cleaning the fuel system. As everything except the fuel system was fine before. I tried running it with the IACV unplugged but did not notice a difference and still stalled. However, the RPM gauge is not in the cluster right now, so I will need to connect the laptop again and use Nistune to check the RPM. I will check this weekend.
×
×
  • Create New...