Jump to content
SAU Community

Recommended Posts

Just saw that Modified Mafia shared the cruise on their page, hopefully they behave themselves

Who are they?

Looks like 47 going from M-M so far...

2x Briefings required at Casula and Albion Park I presume?

I am heading that event. All good blokes and know our rules, few members of it are also SAU members, all will be fine and if we do have issues they will be told to leave. Not to worry.

  • Like 1

Hi Guys,

I will be ion the Pass on Sunday from 10 til 12 ish, I can hang around for you if you would like any photos? If you do leave some room between cars, usual spot, halfway up in the open area. post-139132-0-95137300-1455531606_thumb.jpg

  • Like 3

We need one of these... actually, make it two!

But in all seriousness, we hope everyone will have great time in the cruise without any issues.

Tez, I think we will have to make two briefings. Especially reminding everyone that the official cruise is from Casula Crossroads KFC to the pie shop. The return trip is not under the CAMS permit.

Whats with the perspex halfway up?

Was thinking could run two groups? SAU one and the MM guys in another?

Hi Guys,

I will be ion the Pass on Sunday from 10 til 12 ish, I can hang around for you if you would like any photos? If you do leave some room between cars, usual spot, halfway up in the open area. D75_6188 (Copy).jpg

Hi John,

I've purchased two pics off you before which I'm quite happy with - so thanks.

But if you see a bunch of Skylines coming up the hill, this time, can you slow down your shutter speed a bit and pan?

Regards,...

Hi John,

I've purchased two pics off you before which I'm quite happy with - so thanks.

But if you see a bunch of Skylines coming up the hill, this time, can you slow down your shutter speed a bit and pan?

Regards,...

Mr Fuji Kodak Miagi here....

:cheers::cheers::cheers::cheers::cheers:

Why two groups

Can we get an address and approx time at Albion park for those joining down south

Have updated the thread.

Meet in front of St Paul's Catholic Primary School, Tongarra Road at around 11:00am to 11:30am.

Of course depending of traffic lol.

Point to note:- philhunt and I went back via...

Jamberoo Mtn Rd > Jamberoo > Kiama Rd > Swamp Rd.

The rough bits of Swamp Rd back to the Princes Hwy have been smoothed out in most places and hot mix tarred. It's a great driving road once again (unless trucks chew it up).

HWP appeared in 4 cars (1 unmarked), and seemed to use a sledgehammer approach today.

One in the blue car threatened me to leave the rock wall hairpin lest I get booked. I'm still puzzled about what the ticket would be written up for?

Anyway I didn't get a chance to complete my vid. Sorry about that guys.

I did get a marvelous run up the hill though.




  • Similar Content

  • Latest Posts

    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
    • Yeah dunno why johhny posted that here with no context, just post on FB/insta bro where he put it up?  Laine had an off at T4 during Thurs prac, he's ok, car is less than perfect, they are done for the weekend, he can fill in the rest. Bando also binned it like 100m up the road.   
    • I feel there must have been a FB/insta post and the weekend did not start well at all I hope everyone is all okay
×
×
  • Create New...