Jump to content
SAU Community

Recommended Posts

BCNR33 Vs BNR34 front brake caliper threads

Hi,

I have a set of R33 GTR Brembo front calipers.

They came without the hard lines or any brake lines or fittings but do have the "olives" still on them.

I wanted to retain the factory flared hard lines so i bought a set of BNR34 hard lines with aftermarket braided lines since both BCNR33 & BNR34 share the same part numbers in both Nissan & Nismo data.

I tired fitting them to the calipers but they do no't seem to fit due to a different thread on the caliper and hard line bolt,

Do BCNR33 & BNR34 front calipers have different threads?

Thanks!

Mebbe....but I think he means the thread where the brake line goes into the caliper.  I don't know if they are different but I would have thought 99% they are they same. Maybe see if a tap in the thread cleans it up

I did mean the thread where the brake line goes into the caliper.

Anyone knows what thread tap should i use? threads don't look dirty honestly...

I'm starting to suspect the previous owner tapped the calipers to a different thread since no one encountered such a problem.

Edited by alonroz

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...