Jump to content
SAU Community

Recommended Posts

R32 Gtr Has Constant AWD

Hi guys, 4WD light is on but my car is constantly awd, I pulled out both awd fuses and it was still sending power to the front wheels, (I had the car on a hoist). I have found that the awd bleeder connector in the driver side kick panel is there but there is no plug or wires coming from the boot into it. There is also a small loom cut before the pump in the boot. I noticed when the car was on the hoist on the front right wheel was spinning the same speed as the rears but the front left was stopped. Also when I took the car around the shop it would shutter when turning and if you accelerated a little and backed off it would clunk harshly.
Any ideas?

Link to comment
https://www.sau.com.au/forums/topic/472016-r32-gtr-has-constant-awd/
Share on other sites

It's definitely electrical, the loom to bleed is cut, there's a loom in the boot that's cut just before the fluid reservoir, also there is a grey 2 pin plug that has been cut underneath the car where the motor is. i had to bleed the system by turning the car on and off a couple of times. I will get some more photos tomorrow

If i jack my car up all 4 wheels off the ground and flick the switch on my 4wd controller to 2wd (same as pulling the fuse) I still get some front wheel rotation however nothing on the torque split gauge and you can grab the front wheels and hold them stationary. flick the switch back to 4wd however and as soon as the clutch it let out torque gauge will show some reading and front wheels won't let themselves be stopped.

My Guess is your 4wd isn't engaging at all, hence the light being on on the dash.

  • 2 weeks later...
  • 3 weeks later...
  • 1 month later...
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...