Jump to content
SAU Community

Spark plug change now engine misfire

AnalStick

By AnalStick,
in General Maintenance

 Share

Recommended Posts

AnalStick Enthusiast

AnalStick

Posted
Posted

So i just changed my sparkplugs on my r34 everything was fine I drove it for like 10 minutes and then the engine light came on and then it started misfiring really bad, now on idle, it sounds like its running on fewer cylinders. I got engine fault code 21

Duncan Grand Master

Duncan

Posted
Posted

moved to general maintenance.

and.....have you checked everything since the drive? all plugs tight, all coil packs securely bolted down, all coil pack loom plugged in OK? And the coil pack earth if you undid it?

Dose Pipe Sutututu Grand Master

Dose Pipe Sutututu

Posted
Posted

Or the plugs in there before were gapped very small, and now new plugs have a larger gap.

Or old plugs were gapped stupid small on purpose to mask any coil pack issues. If the coil pack's colour is on the left hand side of the colour spectrum then there's part of your problem.

Dose Pipe Sutututu Grand Master

Dose Pipe Sutututu

Posted
Posted

You'll find coil packs in the following colours, ie the left hand side of the colour spectrum are 9/10 the root of your problem(s) with a car that is running more than stock boost.

Red Orange Yellow Green? (Eventually) lol.

Anyone remember ROYGBIV? 

AnalStick Enthusiast

AnalStick

Posted
  • Author
Posted
3 hours ago, Dose Pipe Sutututu said:

You'll find coil packs in the following colours, ie the left hand side of the colour spectrum are 9/10 the root of your problem(s) with a car that is running more than stock boost.

Red Orange Yellow Green? (Eventually) lol.

Anyone remember ROYGBIV? 

I forgot to mention my car is non turbo 

Dylannn Enthusiast

Dylannn

Posted
Posted (edited)

what coilpacks you running Anal? I've got some OEM ones if you need, $20ea.

I'd do the following diagnosis

Remove 1 coilpack and start the car and see if the miss gets worse, if the miss gets worse then you know that coilpack / plug is working as it should be for that cylinder, repeat this for all cylinders and you should find out which cylinder is not firing. Once this happens swap a known good coilpack onto this to determine if its the coilpack at fault or something else..

 

Report back findings!

Edited by Dylannn
AnalStick Enthusiast

AnalStick

Posted
  • Author
Posted
5 hours ago, Dylannn said:

what coilpacks you running Anal? I've got some OEM ones if you need, $20ea.

I'd do the following diagnosis

Remove 1 coilpack and start the car and see if the miss gets worse, if the miss gets worse then you know that coilpack / plug is working as it should be for that cylinder, repeat this for all cylinders and you should find out which cylinder is not firing. Once this happens swap a known good coilpack onto this to determine if its the coilpack at fault or something else..

 

Report back findings!

Thank you I'll do the testing as soon as I can 

AnalStick Enthusiast

AnalStick

Posted
  • Author
Posted
5 hours ago, Dylannn said:

what coilpacks you running Anal? I've got some OEM ones if you need, $20ea.

I'd do the following diagnosis

Remove 1 coilpack and start the car and see if the miss gets worse, if the miss gets worse then you know that coilpack / plug is working as it should be for that cylinder, repeat this for all cylinders and you should find out which cylinder is not firing. Once this happens swap a known good coilpack onto this to determine if its the coilpack at fault or something else..

 

Report back findings!

so i started my car and it ran fine and again after driving and warming up the engine the engine light came on after about 10 mins. then it slowly started getting misfires as i kept driving the car. could i have put a vacuum hose in the wrong place

Dylannn Enthusiast

Dylannn

Posted
Posted

 

32 minutes ago, AnalStick said:

so i started my car and it ran fine and again after driving and warming up the engine the engine light came on after about 10 mins. then it slowly started getting misfires as i kept driving the car. could i have put a vacuum hose in the wrong place

Check codes on ECU, that will point you in the right direction from here

Dylannn Enthusiast

Dylannn

Posted
Posted
12 minutes ago, AnalStick said:

i did a code check and i got code 21 which means ignition signal, its very vague 

I’d try diagnosis outlined above and see if that helps finding what’s causing the issue

Jjtxaz24 Collaborator

Jjtxaz24

Posted
Posted

Check and make sure your pigtails on your injectors are good. Just push em in, unplug em, clean em and add some dialectic grease. 

I had a misfire and after changing coils, plug, harness and ignitor box i ended up jiggling the injector plug on the cylinder that was misfiring and issue was resolved.  

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kinkstaah
      Mistakes were made, my R34 Story

      By Kinkstaah · Posted

      The car remains in paint jail. I am now pretty convinced that the whole "RB25 Airboxes are kinda limiting to ~300kw" could be a thing. Also saw a good video from Engine Masters: (Sorry for FB link) (https://www.facebook.com/watch/?ref=search&v=761771519471924&external_log_id=c10bcbb6-2c39-4ff3-9240-287e9921fde6&q=Cold Air Considerations) Where they tested Pod Filter sizes and kept adding bends to a LS3 on an Engine Dyno to find if bends caused power loss. It's a good video worth watching - They did lose ~25hp from making an intake which had 3x90's and a 120 degree. They only lost maybe 1hp with a basic 90. I feel that by sealing up my airbox I have: 1) Created the same restriction a stock airbox would have. 2) Created a very convoluted set of intake 'pipes' by forcing all the air through the ducts. So I am pretty confident I'll be going full circle and have a huge hot air intake pod and actually see a benefit. The air does *not* stay hot once it gets flowing, aided by the ducts, and the pod can then pull air from anywhere. All the posts of yore talk about the stock airbox costing 10-15kw at 300kw+ but you know what? I f**king would very much like that 10-15kw and I remember my own pod filter in engine bay experiences. Turns out the GTT Reo and Headlight brackets really don't allow you to mount GTR items, no matter what the internet says. Various brackets have had to be made up to actually make it fit right for the front bar. Also some idiot mounted a 3L Accusump right where the bumper wants to go, so that has had to be 'relocated' To where, I am still not sure, but it's supposedly mounted in the pictures and I can't see it.
    • MBS206
      Factory oil temp sensor in a RS4V without gauges?

      By MBS206 · Posted

      Sounds like the oil pressure light is wired into the oil temp sensor... As it warms up, resistance on temp sensor reduces, hence more current can flow and the dash light gets brighter.
    • acsplit
      Torana Lx Gtr Hatch, Lots Of Pictures

      By acsplit · Posted

      f**k yeah, looking good
    • turbo76lx
      Torana Lx Gtr Hatch, Lots Of Pictures

      By turbo76lx · Posted

      Got the front subframe and suspension in.    
    • Dose Pipe Sutututu
      R34 GTT AC short cycling ? Normal behaviour?

      By Dose Pipe Sutututu · Posted

      If it's cold in summer, then no issue. If it's cutting out every few seconds and you're not reaching your target temp, then there's an issue. One could be the pressure switch and the other issue could be the temp probe inside the evaporator.
×
×
  • Create New...