Jump to content
SAU Community

Recommended Posts

Hey guys, my first post on here. So long story short I own an R33 Skyline Series 1 RB25DE auto from 1993, and its completely stock. I went down to the shops and the car was driving fine, started fine etc.. but when leaving the shops, I did what I normally do by putting the key in the ignition, turning it to the "ON" part, clicking the immobiliser button in, and the dash lights/ radio all lit up as usual for a second or two, and just before i turned the key to start the engine the dash lights/ radio lights just shut off. I had my mechanic whos a family friend come out to look at it, as I suspected it was maybe a flat battery, but we were getting 12.57V to the battery in the boot, we tried to jump start but to no avail. Something else that was odd was to the terminals in the engine bay where you can jump start from also, we were getting no voltage reading, but he said it may have been because the terminals were so dirty. He seemed to think it could be a fuse issue or immobilser but he didn't have the tools to help/ didnt wanna mess with the immobilser or fuses. My cars stranded at the local shops for 48hrs until I can claim service from RAC as I only just signed up for it tonight. Has anyone had a similar issue or maybe could point me in the right direction as to what is wrong with it? Also theres a little red light that will flash 24/7 next to the ignition and when the key first gets put in (without turning at all) theres a beeping sound which I suspect is the alarm, but even that red light wont flash at all. I hope this isn't the end of the road for my car :( any help would be greatly appreciated, thanks guys

Edited by Kyle1234

Didnt make it completely clear, but in short the dash lights wouldn't turn on at all. No crank either when turning key which usually would mean flat battery also. Theres a little green light on the immobilser that will light up when pressing it, and that is lighting up fine, so I guess its not a dead battery in my immobilser? 

18 minutes ago, Kyle1234 said:

Theres a little green light on the immobilser that will light up when pressing it, and that is lighting up fine, so I guess its not a dead battery in my immobilser? 

Doesn't take much power to light that little lcd mate, my remote stopped operating the immobilizer, but was still lighting up. Batteries are cheap. Also check your earth lead.

Edited by Rusty Nuts

Auto-elec will work out what is wrong with it in about 5 minutes. It will be the ignition switch failed, or something equally dull. Or maybe the shitty immobiliser thing hiding in there. In which case your auto-eleccy will curse your name as he pulls it out because they hate them because they do this sort of shit.

You should just pay for a tow to get it out of the carpark and into a workshop.

47 minutes ago, trel said:

Another thing before calling an auto elec just pull out fuses one by one if you can't find the English translated panel on the net and look for a busted fuse,  replace with same rating as necessary. 

With your alarm system, did you remove that yourself? I found an image on google that as this but im not sure what category the alarm fuse would be under. I might just wait till RAC can help tomorrow night, and if they cant then get an auto elec to come look at it, i would have a go myself but i just dont wanna fk it up moreImage result for r33 fuse box english

You're not looking for the fuse that feeds the alarm. You're looking for ANY fuse that might be blown and hence interfering with the car starting.

Any decent alarm installer should never take power from a fused source in the fusebox. They should take power direct from a hot feed and the alarm should have its own fuse.

4 hours ago, GTSBoy said:

You're not looking for the fuse that feeds the alarm. You're looking for ANY fuse that might be blown and hence interfering with the car starting.

Any decent alarm installer should never take power from a fused source in the fusebox. They should take power direct from a hot feed and the alarm should have its own fuse.

Yeah as gts said. Stick your head under the steering column you should see some wires with fuses on them, most likely for the alarm, check them out. Other than that I can't help anymore.

I got a mobile auto elec to take it out for me car was completely dead. Should cost no more than $200 for a mobile guy to remove it. I paid  $185 for an hour plus his callout. Anymore than that and they're ripping you a new one.

Hey guys, so after getting the rac to jump start the car and get it back tomy house it was still dead, turns out the metal under the bolts where the earth lead comes up to the battery had been painted over, which caused issues, and my earth cable is actually too small and being strangled a bit so gotta replace that. These older rac guys are so knowledgable its crazy, the young bloke who got my car out of the shops just said it was a dead battery but batterys actually fine in the end. Thanks so much to everyone that replied in this thread it helped me a lot to try and diagnose the issue, and get a better understanding! Legends!!

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...