Jump to content
SAU Community

Recommended Posts

Hey everyone. My buddy thinks my R33 GTR might have some slight frame damage. Just took it in for a wheel alignment and these are the results. Is anyone able to clarify this for me? 

 

The car is running on coilovers and is lowered, it also has adjustable toe arms. 

 

Thanks!

 

20210601_194416.jpg

Edited by Aiden7
Link to comment
https://www.sau.com.au/forums/topic/482470-wheel-alignment-results/
Share on other sites

Agreed with Dobz.

Cannot say I see anything unnerving there. Would love to hear the reasoning behind your friends' remark.

FYI two things;

Even if you somehow adjust everything on both sides to same degree and minute, the moment you bounce the suspension, everything will likely be off by a couple of minutes again. Rubber bushings.

Things being in the red does not equal things are bad. Lower any car and you get christmas theme on your alignment sheet.

With a lowered car if you want to dial back the negative camber, adjustable upper control arms are a must, both front and rear.  They should also help bringing caster and toe back in the green, but as mentioned in previous replies that's not necessary and your specs look fine.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The oil pressure sensor for logging, does it happen to be the one that was slowly breaking out of the oil block? If it is,I would be ignoring your logs. You had a leak at the sensor which would mean it can't read accurately. It's a small hole at the sensor, and you had a small hole just before it, meaning you could have lost significant pressure reading.   As for brakes, if it's just fluid getting old, you won't necessarily end up with air sitting in the line. Bleed a shit tonne of fluid through so you effectively replace it and go again. Oh and, pay close attention to the pressure gauge while on track!
    • I don't know it is due to that. It could just be due to load on track being more than a dyno. But it would be nice to rule it out. We're talking a fraction of a second of pulling ~1 degree of timing. So it's not a lot, but I'd rather it be 0... Thicker oil isn't really a "bandaid" if it's oil that is going to run at 125C, is it? It will be thicker at 100 and thus at 125, where the 40 weight may not be as thick as one may like for that use. I already have a big pump that has been ported. They (They in this instance being the guy that built my heads) port them so they flow more at lower RPM but have a bypass spring that I believe is ~70psi. I have seen 70psi of oil pressure up top in the past, before I knew I had this leak. I have a 25 row oil cooler that takes up all the space in the driver side guard. It is interesting that GM themselves recommend 0-30 oil for their Vette applications. Unless you take it to the track where the official word is to put 20-50w oil in there, then take that back out after your track day is done and return to 0-30.
    • Nice, looks great. Nice work getting the factory parts also. Never know when you'll need them.
    • Thanks @jtha7 I will have a look around tomorrow but it is a prick of a spot. These are some photos i tried taking 
    • I take it that the knock retard is from bearings tapping a little tune? Thicker oil is a fragile bandaid. You need a much bigger oil cooler and probably the bigger pump being discussed.
×
×
  • Create New...