Jump to content
SAU Community

Recommended Posts

Just curious anyone running anti lag tune on a bi turbo setup… guessing the benefits aren’t too rewarding … to be honest I do the like the shooting flames on revving though … I know it might not be good for the longevity but i do think I would enjoy the flame shooting in front of crowds. Take it however u would like, 😭

Link to comment
https://www.sau.com.au/forums/topic/485665-anti-lag-on-bi-turbo-setup/
Share on other sites

57 minutes ago, Sleepergm said:

Just curious anyone running anti lag tune on a bi turbo setup… guessing the benefits aren’t too rewarding … to be honest I do the like the shooting flames on revving though … I know it might not be good for the longevity but i do think I would enjoy the flame shooting in front of crowds. Take it however u would like, 😭

Engines are expensive. You already mentioned having thermal management issues with your car, anti-lag dramatically raises EGTs and can easily damage a cylinder head. If your goal is actually to improve transient response I recommend VCAM. DBW can also help here. Instead of a simple mapping of accelerator pedal position to throttle opening instead you interpret the accelerator pedal as a certain torque/power request and the throttle will open more or less to achieve that. So if your desired acceleration requires getting 0.5 bar of boost the throttle will silently go wide open to spool the turbos, then as it gets to that target intake manifold pressure it will adjust the throttle back to the steady state target. Another trick you can play is detecting when a shift is happening using a strain gauge and clutch switch for example and rather than snap the throttle shut when the accelerator pedal closes you cut fuel injection and hang the throttle open to keep the turbo from slowing down. This is a pretty complicated trick to play though as if it got stuck in that logic you would have engine runaway and you want to make sure the engine RPMs actually fall at a reasonable rate instead of rev hanging badly.

  • Like 1

Sounds like all you want is a button on your CAN dash pad that is for 2-step / anti lag launch. 

Hold the button down, rev limit gets set to whatever you want, say 5000 rpm. Then mass timing is pulled and a heap of fuel is dumped in for fun times. Want more bangs and flames, pull more timing or add more fuel or both lol. 

Obviously the more you use the fun button, the shorter the life of the entire hot side of your motor. So valves, turbo, cat, any sensors in the exhaust, etc etc.

1 hour ago, Sleepergm said:

guessing the benefits aren’t too rewarding

Well, if you are using it for its intended purpose it is very rewarding. If you are at the drags and want to launch on full boost, how else are you going to do that?

  • Like 1
4 hours ago, GTSBoy said:

I thought you were concerned about being arse raped by the HK police?

Hahah yeah but a man got to do what a man wants to do. Won’t be using it infront of the 5O anyway. My car is illegal as is with the mods. 

2 hours ago, Murray_Calavera said:

Sounds like all you want is a button on your CAN dash pad that is for 2-step / anti lag launch. 

Hold the button down, rev limit gets set to whatever you want, say 5000 rpm. Then mass timing is pulled and a heap of fuel is dumped in for fun times. Want more bangs and flames, pull more timing or add more fuel or both lol. 

Obviously the more you use the fun button, the shorter the life of the entire hot side of your motor. So valves, turbo, cat, any sensors in the exhaust, etc etc.

Well, if you are using it for its intended purpose it is very rewarding. If you are at the drags and want to launch on full boost, how else are you going to do that?

Thanks for the info… guessing less rewarding for my hks ss turbo setup. Might just be more beneficial for a single turbo. I’m just concerned it will hurt my engine long run which would be very expensive. 

2 minutes ago, Sleepergm said:

Thanks for the info… guessing less rewarding for my hks ss turbo setup. Might just be more beneficial for a single turbo. I’m just concerned it will hurt my engine long run which would be very expensive. 

Well not really, 2-step doesn't care if you have 1 or 2 turbos. It will function the same either way, it will let you build boost while stationary. 

You should be concerned, it will 100% hurt your engine in the long run. But you want to shoot flames and have crazy pops/bangs yeah? lol. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...