RB25DE NEO with Haltech ECU

[Haggerty]

I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged. 

I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  

[MBS206]

You very likely need to get it on a dyno and tune it.

My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum.

What O2 sensor are you running?

 

When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?

[Haggerty]

Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated.

It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings.

I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section.

I have the Bosch 4.9 from Haltech.

My manifold pressure when watching it live is always in -5.9 psi/inHg

Edited 4 hours ago by Haggerty