Jump to content
SAU Community

Recommended Posts

Hey guys,

last minute decision here!!  

What the difference between the gts4 or the gtst ?

I need an answer asap! which is the best car ?

Thanks!

(i need some specs on both cars stock)

The BEST is what suits you and your driving requirements.

To ME, the best is the GTS4! (R32 - TURBO) R33 NA.

In 1997 I wanted an AWD Skyline Turbo and the GTR was over $50K!

So I paid $33K for the GTS4, an Auto, it was available in Black the colour my wife and I wanted. (She had to sell her car so we could buy it :Oops:

Never looked back since, although the Auto needed to be fully rebuilt, -Kevlar clutches 2800 Stall etc. $3K 3mths!

The specs of the RB20 (R32) are very similar in both cars wether auto or manual, but the GTS4 is virtually GTR running gear except drive shafts smaller. So it weighs a bit more obvoiusly. Around 100Kg I think. Has the advantage of AWD and if I want RWD I just pull the fuses to the Transfer clutch pump motor.

OK, so its "Wife of Godzilla" but to me thats the next best thing. :)

Last dynoed at 170Kw but hunting for more. (14.1 @98Mph 2.6 0-60)

Link to comment
https://www.sau.com.au/forums/topic/48858-r32-gtst-gts4-or/#findComment-980484
Share on other sites

2.6 60ft ???  That's pretty slow even for a GTS-T.

Scott

Its an auto, and it was my first time out the drags with it.

Probably the last too, considering the damage and time off the road :Oops:

Link to comment
https://www.sau.com.au/forums/topic/48858-r32-gtst-gts4-or/#findComment-980582
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You can use your VIN to look up the factory part number somewhere like amayama, and then look to order new if necessary. https://www.amayama.com/en/genuine-catalogs/nissan Depending on price you might want to rebuild instead. @GTSBoy I had an interesting insight into US market parts when the Titan rear calipers were sticking. New calipers were dirt cheap, about 20% more than a rebuild kit....they are just considered throw away maintenance items
    • Funny, but really not funny. Thank god (most) f the world has moved on since then
    • Lots of votes for driving onto a plank first; that is the quickest way I've found, 25mm is enough for my case but that will vary by car It also depends where you are going for. On the 32 I can get to the rear diff with my floor jack if I do that end first, and get it up on stands. Then I lift the front from either front tow hook as high as needed, also onto stands. Sometimes I need a small lift on the other tow hook to get it level enough If I do the front first I can't get to the rear diff because of the angle of the car Other options are getting to the front mount of the rear subframe from in front of the wheel (if only lifting one side, or just do both which is a bit of a pain compared to one lift from the diff), or also the gearbox cross member mount on the driver's side if you are  just trying to lift the driver's side. I This is the jack I use; it says 75mm clearance but of course that is only on the lower section so if you have to reach too far in like the diff you still get stuck. https://www.snapon-bluepoint.com.sg/category/Floor-Jacks/product/Floor-Jack,-2-Ton-Low-Profile
    • On the bright side, the weather will turn much nicer for working outside shortly....sounds like you might need to start on a neighbour's garden next
    • Ok so i will NEED to have this sensor anyway even with Nistune (or standalone ECU) https://justjap.com/products/genuine-nissan-boost-pressure-sensor-evap-control-system-fits-nissan-r34-skyline-c34-nm35-stagea-pnt30-x-trail-rb25det-vq25det-sr20vet?currency=AUD&srsltid=AfmBOoqfxX48bW9bEwH62orcNhtBfp7ekAL0C9Ca89ySFGUiBzXfXeze Is this the correct one? And this is only thing i need? No other "things" connected to the sensor or something? I do have the wiring.
×
×
  • Create New...