Jump to content
SAU Community

Recommended Posts

  • Replies 63
  • Created
  • Last Reply

Top Posters In This Topic

Has the car ever had frontal damage that might affect the axles etc? If not then I might be interested in the whole front axle with wishbones etc.

Oh and the speedometer cable as well... definitely need that.

No front end damage from what I can tell, mainly driver side and roof, from people standing on it not from rolling.

I may need the speedo cable as I planning on using all the bits from the R32 to convert my Cef to five speed, gunna use the R32's donk aswell. Or are cefs electric speedo?

dunno... i'll let you know when I take my ceffie apart :cheers: which should be soon as I'm putting a laure C33 dash in.

If you don't need the cable, then let me know via PM or email [email protected]

Do you have this piece of plastic? It sits under the top of the bonnet (near the windscreen), under the wipers:

windscreen-part.png

Also after the centre console rear ashtray (don't smoke, just looks weird having a hole) :D

Cheers,

Lucien.

Not sure on the rear windscreen moulding. Its a fscker to get off without damaging it so I might be better off just buying a new one (and being raped by Nissan) unless yours is already off and in good condition :D ... ?

Lucien.

Mine is probably pretty sun dried by now, Ill see how i go getting it out.

Heh. Good luck. It was a bastard on mine. 15 year old silicon (and stacks of it) didn't want to give :)

Lemme know how much you want for the rear ashtray.

LW.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...