Jump to content
SAU Community

Recommended Posts

If anybodies interested the 1st round of the NSW Championship is on this Sunday. It's being held at the Quakers Hill TAFE and is being run by Thornleigh car club. I'm going,,,hope to see some of you lot there.

Neil.

Link to comment
https://www.sau.com.au/forums/topic/66781-motorkhana-2005-1st-round-13305/
Share on other sites

well, its got 2 rear ends....but since none are connected.

Anyone who comes over to install it tomorrow can race the datto on sunday :D

Mat, it is great fun and dead cheap, get out there for sure. You will need CAMS club membership and a L2NS CAMS license to enter, I'm sure the club running the day can help you out with both. SAU NSW is a CAMS club but you won't really have time to join before then :)

Poor Datto still has no rear end :)

Hey Tosh get some grease under your fingernails boy. I'd help ya but I'm playing skid pan tommorow and Motorkhana on Sunday. Feel free to ring me If you get stuck and need advice though.

Neil.

Bugger Dino looks like I'm doing another one on my own. But I could be wrong,,,,Toshi-san might have fixed the 810.

Plan for me this year is to win class D and kick that Peugeot 405's arse. Why I have to compete against a front wheel drive I'll never know.

Neil.

Duncan I've worked some of it out. The rules say if theres less than 3 in any one class they will be merged into another. It didn't matter in the end cause he brought a RWD one anyway.

I basically screwed up,,,As you well know money is being channeled elsewhere and I had to use crapy old tyres. Traction was a non event. I did actually lead the D's for a while but as the day went on the car got undrivable to the point of basically wheel spinning whenever I got on the throttle.

Neil.



  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...