Jump to content
SAU Community

Recommended Posts

Mate,

I don't know who you are but you have been signed up to SAU for less than 2 months and you already have over 1000 posts.

Thats an effort that needs to be recognised and rewarded (so here's a fruit bowl)

ST_46_Fruit_Bowl.jpg

Even our old friend Rob would be impressed with this effort. At this rate you might even catch Ni by the end of the year!

I personally can't wait to see what happens to your post count when you actually own a skyline! God help the SAU bandwidth!!

Anyways..... keep up the good work!

B)

Link to comment
https://www.sau.com.au/forums/topic/89050-att-madwob/
Share on other sites

I currently have 4 people (thats everyone in today) in my office staring at me, wondering why I'm laughing - Thanks Snowball!!!!!

Why is the bowl of fruit wearing a belt?

Is it scared its pants will fall down?

^ and that is gold!!

Link to comment
https://www.sau.com.au/forums/topic/89050-att-madwob/#findComment-1608311
Share on other sites

he isnt embarrassed....he's been working non stop

he's home now, and he has a moment before he goes to bed so that he can wake up at 4:30am and go back to work...

he'd like to thanks, its nice to be noticed

he'd also like to thank the vic wasteland, and hotmail instant email notification, as without those 2, this would not be possible.

Link to comment
https://www.sau.com.au/forums/topic/89050-att-madwob/#findComment-1609270
Share on other sites

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...