Jump to content
SAU Community

Recommended Posts

UPDATE:

Spoke to the ****wit responsible for my engine destruction and the Einstein claims that he drove the car from his garage to the storage yard and the car died on the way there. Mind you, this means that the car moves 15 metres, then goes down one ramp for another 15, then does a hard right 180° into another driveway and then up another ramp for 50 metres, then about 15 metres to where it was "stored". All the while you would struggle to drive the car at more than walking pace. He claims it happened going up the ramp and obviously isn't taking any responsibility for the damage.

It was so funny I almost laughed.

Almost.

  • Replies 67
  • Created
  • Last Reply

Top Posters In This Topic

It is without doubt a bearing seized up locking the rod solid to the crank ,something had to give.

I have never doubte that. The car was stopped and towed as soon the bearing knock developed.

it is this mysterious 100m drive that is the issue.

Nick and shif_tea

Only problem there is that he doesn't have any laundry...

ross80, thanks for the newsflash, Captain.

nxtime,

my r33 developed a knock and at first i thought it was a noisy tappet so i was on my way to get some new oil, and it seized.

My bottom end bearing spun and disinegrated similar to yours but my conrod didnt snap (however it was ground out by the ring. The grooves in the block were unrepairable, the crank was f**ked and the head was only just repairable with a grind, which i ended up selling for $800.

My dad is a mechanic and he puts it down to a failed oil pump.

You towed it to this place because you wanted to alleviate any further damage and then he drives the car and it breaks????

In regards to how he might or might not of driven it my best friends built rodeo engine spat a rod out two years ago and car was travelling at about 30km/h on cruise do a bearing being starved so it is possible but its no RB so I guess its irrelevant.

You mentioned it went up a 50 metre ramp, so is it possible that if he took this ramp in too tall a gear that the pictured damage could be the result of the excess load and ill bottom end?

wether he thrashed it or idled it doesn't matter.

you towed it there with a problem, then they DROVE it to storage, it broke.

they are liable.

I say go there, with a tape recorder and say "After I had my car TOWED to you with the instruction that it has a knock sound, what EXACTLY happened from that moment until the time my block got a "speed hole". "

it's legal to record a conversation if ONE party knows it is being recorded.

that be you!

What must be considered is that he CLAIMS that the car was driven less than 100m and died going up the ramp.

Now, my car has been driven up that 45° ramp before and even if you gave it 100% throttle, it will not accelerate hard due to the large cams etc.

The bottom line is what he claims and what actually happened are two completely different things.

GTST, you are correct. It came on a tow truck because it developed a bearing knock. It SHOULD NOT have been driven at all.

But Einstein decided to drive it, and by the damaged caused, it most definitely wasn't driven a few metres up to the storage yard. It has obviously been thrashed.

What must be considered is that he CLAIMS that the car was driven less than 100m and died going up the ramp.

Now, my car has been driven up that 45° ramp before and even if you gave it 100% throttle, it will not accelerate hard due to the large cams etc.

The bottom line is what he claims and what actually happened are two completely different things.

GTST, you are correct. It came on a tow truck because it developed a bearing knock. It SHOULD NOT have been driven at all.

But Einstein decided to drive it, and by the damaged caused, it most definitely wasn't driven a few metres up to the storage yard. It has obviously been thrashed.

If u can get him to admit he drove the car at all he will be liable. That fact that u didnt tell him to not drive the car is irrelevant. That would be implied since u had the car towed to the workshop.

Who is this guy btw so i know neva to take my car there!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I know I have to get a wheel alignment but until then I just need to bring the rear tyres in a bit they're wearing to the belt on the inside and brand new on the outside edge. I did shorten the arms a bit but got it wrong now after a few klms the Slip and VDC lights come on. I'd just like to get it to a point where I can drive for another week or two before getting an alignment. I've had to pay a lot of other stuff recently so doing it myself is my only option 
    • You just need a wheel alignment after, so just set them to the same as current and drive to the shop. As there are 2 upper links it may also be worth adding adjustable upper front links at the same time; these reduce bump steer when you move the camber (note that setting those correctly takes a lot longer as you have to recheck the camber at each length of the toe arm, through a range of movement, so you could just ignore that unless the handling becomes unpredictable)
    • I got adjustable after market rear camber arm to replace the stock one's because got sick of having to buy new rear tyres every few months. Can anyone please let me know what the best adjustment length would be. I don't have the old ones anymore to get measurements. I'm guessing the stock measurement minus a few mm would do it. Please any help on replacing them would be fantastic I've watched the YouTube clips but no-one talks about how long to set the camber arm to.
    • Heh. I copied the link to the video direct, instead of the thread I mentioned. But the video is the main value content anyway. Otherwise, yes, in Europe, surely you'd be expected to buy local. Being whichever flavour of Michelin, Continental or Pirelli suits your usage model.
    • Continental have consistently beaten the absolute shit out of every other performance tyre in Wet/Damp/Cold conditions and give up a little bit of time (half a second at most) in the dry. Almost like it's engineered for German conditions or something. I'd def give those a try.
×
×
  • Create New...