Jump to content
SAU Community

Recommended Posts

I have a single 12" sub in my R33 and I face it towards the end of the car.... Sounds good! I've had a sub pointed into the car in my R31 when i could fold the seats down and almost sit it inside the cabin, but there's not as much bass as being faced the other way and as an enclosed unit (boot)

Just looking at my R32 it seems logical to mount a sub in a sealed box through the plate behind the back seat.(see my posts #18 &

#22 " Where's the bass? " this forum). I've run this idea past a few installers and most have recommended something else for one reason or another. One guy quoted a couple of articles on bass loading in CSA magazine. I found these articles (issues #5 & #9) and I must say that in these tests the forward facing mounting position had the lowest SPL and very uneven frequency response. The main difference between my idea and their setup is that my cabin will be sealed from the boot and their's fires through an open ski-port.

Gester,

The answer to your question is "none of the above"

Try standing in the middle of a room (of any given size) and speak at a normal level. Now go to a corner, face the wall and repeat...

This is why manufacturers of Hi-Fi speakers ALWAYS recommend positioning at least 40-50cm from a side wall - The bass response would lift considerably and "muddy" the soundstage. In a car where you WANT lift face the driver toward the rearmost corner in your boot. You won't win any fashion contests doing this, but you will optimize bass response using the natural acoustics of your car.

Let me know if it makes a difference !

  • 2 weeks later...

wow... almost looks like there is some boot space left there with that setup! :P

My 12" sub should be ariving any day now.. Will be interesting to see what i can do as well. I don't want to lose too much boot, but i know that i will in one way or another.

With bass, low frequencies are a lot more omni directional than higher frequencies, therefore staging is not as important in general in a sub. If you think about it, higher frequencies have less area and therefore bounce around more and are affected more by where it is positioned - so its important to get that part right.

That is why most home theatre applications they generally say you can position the sub most of time where it fits when there is all these theories of where you should be positioning all your other speakers.

I think where you position the sub is not as important as the enclosure (where it develops most of its sound) and the mounting itself (not loose). The key is to make sure there is no non-harmonic vibration or "buzzing" developed. I wonder whether adding sound insulation into the wells and other "open" spaces in there is going to help aswell so less sound can escape?

There is probably a massive art to getting it all perfectly right and requires many complex tools that us peeps probably don't have access to. I'd say unless you do something really stupid its going to sound pretty good - and bass in the end is only part of the equation (for me anyway!)

btw: I don't think that side setup would be that optimal, as really there is really little room for proper resonation behind the speaker, other than the side wells (which are pretty small really and not that effectively shaped)... however you would have good resonation from the front of the speaker, as there is no box filling the rest of the boot. I still think the former is more important though.

I'd say while more practical, you would be sacrificing some volume and quality there.

Originally posted by predator666

With bass, low frequencies are a lot more omni directional than higher frequencies, therefore staging is not as important in general in a sub. If you think about it, higher frequencies have less area and therefore bounce around more and are affected more by where it is positioned - so its important to get that part right.  

That is why most home theatre applications they generally say you can position the sub most of time where it fits when there is all these theories of where you should be positioning all your other speakers.  

you are partly right predator.

in terms of a room, with a large air volume and semi-infinite space, the location of a sub is not "as essential". However, within a car, the primary governance in terms of the effectiveness of bass drivers is the relationship between active and passive wave cancellation.

wavelengths for bass travel are typically in the order of 3m. as governed by c=f x lambda (assuming c=3.3, and f=80 Hz mean). for the best amplitude response, the listener should be positioned at the anti-node of the source. in terms of a woofer driver, this amounts to a multiple of the wavelength.

In short, the MOST CONSISTENT way of acheiving this is to direct the driver toards the back f the trunk. this allows reflecion of the sound wave off rear boot surface (approximately 0.5m) and then travel from the boot to the front of the vehicle cabin (about 2.5m, depending on the car).

this method typically produces best resullts for single driver setups in sedan sized vehicles in terms of SPL. some experimentation may be necessary to determine whether the sound is better when the driver is facced into the LH or RH corner or directly backwards.

  • 3 weeks later...

Gester I'm still undecided as to whether to put the sub behind the seat or in the wheelwell. I don't see it being too difficult to go behind the seat once you've relocated the battery though. I'm still toying with the idea of facing it foward through the arm rest hole but if I do this I can only fit one 10". If i face it backwards I can fit 2 x 12"s easily.

Has anyone managed to put the Sub in the compartment with the battery?

Yep, done it. Single 10" drivers side, facing into the boot, and currently working on the second once I have relocated the battery. 12"s would fit no problem, provided they arent going to be too deep. You can always bring the false wall forward to compensate though, just means less boot space (tis why I have 10") All I need to do now if buy decent 10"s rather than the Sony's I was given :):D

I got mine like the pic above with the driver facing the left suspension tower roughly. Its a solobaric L7 square so the box is absolutely small and the sound is mad for such a small driver in such a miniscule box. also get some brown bread deadener and deaden the boot lid and anywhere else you can fit some if there is any left exspecially the boot floor.

perfect

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi from Canada, Both of my calipers are starting to fail. My car is a 2005 M35 Stagea ARX and I can't seem to find any parts or any cross reference caliper that would fit my car. Is there a company or a similar caliper that would fit and I could replace the OEM one. Or if anyone knows where I can find a new OEM. Any help is very appreciated. Let me know!
    • Maf is a question mark but TPS  I have set at 0.47, the fact that I’m getting proper voltage range out of it with the key on leads me to believe it’s functioning properly. I’m getting proper voltages on basically everything. I still need to look up voltage ranges for z32 maf and test that 
    • Honestly no not at all, but it’s a very basic tune, it’s stock injectors q45 tps and z32 maf. Other than that it’s a completely stock base map. The file is from nistune and from my understanding if it was tune related I would be able to unplug maf and tps and it would still start even if it was a really shitty start. I have tried starting it with coolant temp, maf, and tps unplugged none of those 3 togethor or individually changes anything 
    • 🏆 Skyline Supremacy Meets Mount Panorama Magic 🏆 Join SAU NSW as we take the long way to Bathurst, the home of GTR greatness. Saturday 30th August 2025 7:00AM Meeting Hanna Park North Richmond 7:30AM Departure Cruise Via Bells of Line Road 9:00AM Arrival to Stop 1: Golden Poplars Meadow Flat 9:45AM Arrival to Final Destination: Mount Panorama Motor Racing Circuit Meet Location: Hanna Park North Richmond Stop 1: Golden Poplars Meadow Flat Final Destination: Mount Panorama Motor Racing Circuit   *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • What does it look like with highway driving? And yes, I had a similar thought as Duncan. It looks quite similar in my Stagea and I have made myself accept it as normal. Might have to look into it some day   Highway gets as low as 10l/100km on my end so I'm not as worried about it being a mechanical issue. More likely just the tune on the haltech.
×
×
  • Create New...