Jump to content
SAU Community

Recommended Posts

hi all,

i'm new to skyline cars and i'm thinking of buying an R32 class, either gt-t or gts-t, but not gt-r.

maybe it has been discussed before in this forum. so i'm sorry if i ask the same thing again. i was just wondering about R32 fuel consumption. how much fuel does it consume say if i just drive it normally with low boost. for everyday driving i mean.

thanks before for any replies. :P

Link to comment
https://www.sau.com.au/forums/topic/133299-r32-gt-t-fuel-consumption/
Share on other sites

hi all,

i'm new to skyline cars and i'm thinking of buying an R32 class, either gt-t or gts-t, but not gt-r.

maybe it has been discussed before in this forum. so i'm sorry if i ask the same thing again. i was just wondering about R32 fuel consumption. how much fuel does it consume say if i just drive it normally with low boost. for everyday driving i mean.

thanks before for any replies. :ermm:

hey, I can get about 450 - 500ks to a tank with just normal driving.. well it was hwy driving. Full tank costs me about $80-90+ depending on petrol prices, and thats for premium.

So I guess its not TOO bad. I'm running 12psi too. But start driving it hard thats when you'll just chew through the petrol.

On my last full tank i got 420km when the fuel light came on (normal driving, not a lot of highway driving) with BP Ultimate.

My car is a 92' model GTS-t, with a cat-back exhaust and high-flow panel filter - so it's fairly stock. Haven't yet tested its highway economy :O

Steve.

Edited by R32_GODZILLA

Im only getting 270km~ and thats driving mon-fri in peak hour traffic. Although you can strongly smell premium at the back of the car. Running rich no doubt, will replace sparkplugs and clean afm to see if any changes occur

mods: apexi catback and apexi filter

hey guys , just thought of sharing infos , i get around 400kms per tank for bp ultimate and roughly 450kms per tank with shell, and thats just normal driving i thought earlier my fuel consumption was high, because i heard some doing 500+ looks like its pretty average

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...