Jump to content
SAU Community

Recommended Posts

aight ppl i was being stupid - hit boost suddenly in the wet around a corner - and hve suffered the consequences. luckily i didnt injur anyone but my car's not looking good.

destroyed my front bar, left headlights fully shattered, fender bent, and bonnet slightly warped. it looks like its just cosmetic damage and there isnt anything else wrong with how the car operates (as far as i can c) i need it fixed and soon.

just wanted to any suggestions u guys can give on panelbeaters/repairers in the SE melb area. did a couple searches but all the results are kinda older can anyone tell me if theyr still valid or wat.

pics will b up soon

Link to comment
https://www.sau.com.au/forums/topic/133797-crashed-my-car-need-help/
Share on other sites

Dude bad luck...

Unfortunately we learn from our mistakes...

I know it's not close but:

Gal Smash in Tullamarine is the place to go....

9330 3137 - Speak to Dave

Tell him you know Matt...

I had an accident in my line and he fixed it for me... Im also SE area but went over and saw him and he did a Mint job...

Good Luck with the repairs....

ya those guys are good.

I'm in the east and these guys called Graeme Cuthbert Automotive fixed up my line...did a great job and some custom things under insurance.

They are in Box hill and typically only do euro cars for Just Cars and AAMI.

Good guys really helped me out with special requests.

thanx for the replies guys. anyone else got any info?

i read on these forums that a place called the palm or somthing in moorabbin was ment to be good. but that was like 2 or 3 yrs bak. i know its not that long but can anyone confirm this?

thanx again

any ways here r pics of the result

anDru: nah man i hit in croydon..droppin off the gf home at about 2am

BUMP

whate eva u do dont take it to cpr automotive in dandenong, nufn but shit work and i learnt the hard way

thanks 4 the warnin bro. does any one know how much a bonnet, fender, complete head light, front bar (after market) and the front section of the inner wheel arch are gonna cost to replace? and do u guys rekon there mite be more damage or do u need betta pics?

c'mon ppl i really need to find some repairer whos gunna tak care of my car. i dont know any one personally whos had a skyline need repairs and i dont know whos good with these cars and whos not. i need to access the great fount of knowledge that is this forum. :( (flattery i know but its worth a try rite?)

some help plz

btw thanx 2 those who did help

Edited by Basti

ok oops......just read that thread by inark detailing contacts for wreckers, performance shops etc>_<.

here it is

Performace/import/automotive Related Links**updated 15/7**

its got almost everything i want. only thing missing is ppls opinions on these places. so wile i feel a tad idiotic id still like some feed back on any of these places or others ppl may have experience wit

i was insured by just cars and they sent my car to Classic Panels in dandenong.

they did a good job....spotless cant tell anything....except there were a few things like door not closing properly but it was just a clip :laugh:

EuroImage In Cheltenham is my choice , but they are expensive.

I got them to respray a new commodore i had before my Skyline with GM picking up the tab, very good job.

My Mate George has a very good reputation there,

worth a quote.

thanks for the replies guys. will chek these places out as soon as i am able.

just cars also sent me to Berwick Ultrafinish. they look very proffesional and were very thorough in looking over the car. has any one dealt with these guys before? r they as gud as they seem?

DONT take it to coolstore panels in croydon. I took my car there and they f**ked up the colour, didn't deliver in the time frame they gave me. Never once called me back when they said they would. The lady was a total b!tch to me and when I complained about the colour they didn't want to know about it. They had my money thats all they cared about. Also cracked some plastic bits inside the car.

Phil munday panel works in kilsyth are pretty good I think. Ph: 9725 4111

Edited by Ricey

The good thing is with Just Cars im pretty sure if u take it to a beater they recommend it has a lifetime warranty, so if somethings not 100% theyll re do it.

Ive got a whole R33 front end if your interested?

(Headlights, aftermarket f/bar, fenders and vented bonnet(legal!)

Gal Smash in Tullamarine is the place to go....

9330 3137 - Speak to Dave

Tell him you know Matt...

Mate i stand by this guys work...

seen him fix a repairable write off and it looks MINT!!!!!

i totally agree with matt here

Gal fixed my car when i smashed it in April.

I could go in there and see it anytime i wanted and Dave went out of his way for me heaps.

My car came back looking better than it did when i first brought it and im over the moon with what a top job they did on it.

  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I have been being VERY quiet about what you're alluding to, as it is something that ticks me off... The number of cars from factory that run coil overs is HUGE! Most of them these days do... The other part that annoys me, is people saying "Well all the incabin adjustable suspension is illegal by blah blah blah"... If that's the case, then why can I buy a car brand new that can do it if, FULL STOP in cabin adjustable suspension is illegal...   Also, I could just chuck some aftermarket shocks in my car, throw the stock springs on, after my blue slip, dump my super low springs back in. Same shock and spring style setup... Hell, they could also be the same colour springs etc.     I'm voting, BlueSlipper didn't want to touch the above car for some reason. Whether it be some sort of bias against the car, the owner, them maybe having previously done dodgy shit and now they're being super careful in case they get slapped in the face by the Gumbyment again... Find a new blueslip place.   And can confirm as you had said, yes there are holy bibles of vehicle heights, and all sorts of other suspension stuff. Heck your run of the mill mechanic, and tyre shop has access to all of that stuff. It's how they do wheel alignments...
    • Funny story Heading to Sydney this morning on the HWY there was some slow traffic, so I gave it the beans and midway through my overtaking "power run" I lost all power It seems that I missed a hose clamp,  and the MAF and filter went WiFi To make this more problematic, the little tool kit that lives in the boot, is sitting in the sun room at Goulburn......LOL Luckily for me I found a bit of steel on the side of the road that could be used like a rusty and bent flat head screw driver to tighten it up enough that it got me into Sydney, it is now all tight like a tiger with the aid of a 8mm socket Note to self: Use my brain and double check stuff, and always keep that little tool kit in the car for when I have a brain fart
    • Oh, and as for everyone with their fuel economy changes, I switch between E10 and 98 in the company car. Even do when I had personal cars that could run on E10. You know what changed my fuel economy in any noticeable way? How I drove, and where I drove. Otherwise, say on full tanks of just back and forth from work only (So same trips, same sort of traffic), couldn't notice a difference that I can correlate to the type of fuel in use. In the current vehicle, that's over 42L of USABLE fuel. While 98 is all "more energy dense", it also has higher knock resistance as it takes more energy to get it to ignite too. The longer hydrocarbons, typically more tightly bound. So running the same ignition map, can also produce less power, if there isn't enough time to get it all burnt through properly, as yep, the flame propagation speed is different from lower octane fuel to higher (Higher has a lower flame propagation, due to the more tightly bound and harder to self ignite funs. This is also typically where, a vehicle that is designed purely to run on 91 (Whether it be E10 or normal 91) usually sees absolutely no real world difference in fuel economy for the normal man, woman, or dog.
    • We've got some servos around me that have 91 with E10, 91 (no E10), 95, and 98. At those stations the change from 91 E10 to 91, is typically around 8c/L.   But lets not get started on the price of fuel in Oz. It's ridiculous. All the service stations around me, bar one, the price of fuel has been over the $2 mark per litre for the cheapest, 98 being around $2.45. That one service station is a CostCo, fuel from it comes from the same refineries, and makes no pitstops, it runs great, including the 98. In fact, I've had no issues on CostCo fuel, but plenty of issues at other stations!. The CostCo fuel, was $1.65 roughly this week for 94 with E10. $1.88 for 98. Servos directly across from it, $2.10 for 91 E10, and $2.48 for 98. The part I had to laugh at? If I drive multiple HOURS away from Brisbane, say out near Nanango, or Kingaroy, or even out to Goondiwindi, the price of their fuel, is the same as what it is at the CostCo... Oh, and that BP servo at Goondiwindi is HUGE and goes through epic turnover of fuel, so it's not sitting there for weeks going to shit. And what blows me away, my mate is one of the people who drives the Fuel Tanker all around QLD, delivering to all those places. At the same company his previous role was doing the "local haul" deliveries... Same truck, same driver, same pickup point it all comes from. So you tell me, how the hell it is 60c/L CHEAPER for fuel, when nearly all else is equal, except they require a B-Double to drive half a day out of Brisbane, and half a day back, every second day, compared to the delivery that can be under 30 minutes drive from the fuel pickup point... Not to mention, go five blocks down the road, and Ampol to Ampol will vary 30c/L... And I've had this conversation with my mate... The way it's priced, is just typical, pure and utter rubbish... He also does runs from Brisbane, to all over QLD, down to Newcastle, Sydney, Nowra, Melbourne, Geelong, and even out to parts of the NT depending on the companies needs. His main stuff is all the longer distance away from home for a few days at a time, then when he's back, he loves to just pickup extra shifts wherever he can in whichever truck, hence all the weird different places.   Oh, as for getting E10 into all the fuels in Australia... It was very quickly highlighted, that we don't have enough biomass available to use to make E10 sustainably like they require, and it would dramatically cut into our, and the worlds food chain supply...   I vote we all just start running on liquid methane gas... Plenty of that just getting tapped off at tips from underground decay... (Note, this is pure just stupid commenting. I could very easily highlight the reasons its not a good idea especially on scale...)
    • Am I correct in assuming that the R35's are getting the classic skyline haircut off the odometer?  Quick search on carsales, there are 33 08 and 09 GTR's for sale, only 2 of them have more then 100,000km's on them (116,075 and 110,000 respectively).  And somehow there are about 25 for sale with around 60,000kms? Looks like the classic skyline haircut to me =/
×
×
  • Create New...