Jump to content
SAU Community

Recommended Posts

  • 2 weeks later...

1998 EL Falcon

NA6 4.0L

lots of headwork, big cam, 3" exhaust, Wolf V500, ICE ignition, CAI.

198.9rwkw

That's a good figure man, any vids?

I'll have to post up some figures when the LS eventually gets tuned

  • 7 months later...

2007 V36 370GT VQ37HR 3.7L V6 5SPD AUTO

Modifications:

Cat-back exhaust pipes

Hi-flow panel filters

2011-09-17165602.jpg

Apparently car runs rich from factory, bit more power to squeeze out of it if I can lean of the a/f ratio a bit

Stock Power run done close to when I first got the car for reference:

2011-09-17165537.jpg

th_video-2011-09-17-11-49-21.jpg

Hey mate, just wondering if you had the 180km/h limit when you did the dyno run as you have not mentioned an a/m ecu, if yes what gear was the run done??? cheers

Hey mate, just wondering if you had the 180km/h limit when you did the dyno run as you have not mentioned an a/m ecu, if yes what gear was the run done??? cheers

By the speed, 3rd automatic.

4th gear will be in the limiter.

  • 3 weeks later...

Naturally aspirated RB26/30 R31 Skyline build-

Nitto high volume rb oil pump
Nitto h-beam connecting rods
Nitto crank collar
Nitto high compression custom pistons
ACL Race bearings - mains / connecting rods
ACL Race ProSeal engine gasket kit
Brian crower 1mm oversize valves
Ross metal jacket balancer with cam / crank trigger kit
N1 water pump
Nismo low temp thermostat
Oil restrictors

Camtech RB26 camshafts
Camtech valve springs and titanium retainer kit
Custom made ITB setup
XSpurt injectors
Heavily ported cylinder head
Link G4 Storm ECU
Genuine Nissan front / rear seals, idler and tensioner
Custom Gates belt

IGN-1A race coils

Dyno sheet - Mild Tune (will push it a bit later when its proven to be all well)
Engine torque is that divided by the diff ratio. 3.7 in this case
Annnd its on a hub Dyno hence the power curve "interuptions", if it was on a roller it would be smooth as silk.

ildn40.png

2pr93jn.jpg

  • 1 month later...

Naturally aspirated RB26/30 R31 Skyline build-

Nitto high volume rb oil pump

Nitto h-beam connecting rods

Nitto crank collar

Nitto high compression custom pistons

ACL Race bearings - mains / connecting rods

ACL Race ProSeal engine gasket kit

Brian crower 1mm oversize valves

Ross metal jacket balancer with cam / crank trigger kit

N1 water pump

Nismo low temp thermostat

Oil restrictors

Camtech RB26 camshafts

Camtech valve springs and titanium retainer kit

Custom made ITB setup

XSpurt injectors

Heavily ported cylinder head

Link G4 Storm ECU

Genuine Nissan front / rear seals, idler and tensioner

Custom Gates belt

IGN-1A race coils

Dyno sheet - Mild Tune (will push it a bit later when its proven to be all well)

Engine torque is that divided by the diff ratio. 3.7 in this case

Annnd its on a hub Dyno hence the power curve "interuptions", if it was on a roller it would be smooth as silk.

2pr93jn.jpg

Post up a sound clip or vid, I wanna hear those ITBs :yes:

  • 2 months later...

That's a good figure man, any vids?

I'll have to post up some figures when the LS eventually gets tuned

So yer only took me a year to get around to it. Cam only through a stalled auto ;)

6mbnYBv.jpg

Oneaeug.jpg

  • 7 months later...
  • 4 weeks later...

Hello, I have a 1998 R34 coupe and im having some weird problems.

The other week i got in to drive it and when i unlocked it problems started,

1. The tacho and speedo dont work,
2. The bell chime for door didnt chime,
3. The interior light stays on,
4. The passenger door wont lock with the button on the remote or drivers side panel.

It still starts and drives fine,
I disconnected the battery and reset the ECU which worked, but then it happened again and again now that trick only works sometimes.

Any ideas thanks

  • 4 months later...
  • 3 months later...
  • 1 month later...

R32 GTS25

RB25DE (small port non VCT R32 RB25)

CAI

Fujitsubo extractors. 2.25 straight through exhaust.

Mild port - exhaust side only.

Poncams.

Tomei cam gears (0 deg on both was actually the sweet spot surprisingly)

Nistune.

98 octane.

158.7hp atw.

Tuned by Matt Spry.

Link to dyno sheet below.

https://fbcdn-sphotos-e-a.akamaihd.net/hphotos-ak-xtp1/t31.0-8/11062004_1013167325369234_3421555629321155321_o.jpg?efg=eyJpIjoidCJ9

  • 7 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • BRUH, one of the biggest mistakes of my life..... and i've had plenty ;[)
    • @Murray_Calavera iam just considering options 🙂 of course it is very expensive so that why i ask here 🙂  @joshuaho96 I looked at that GCG hybrid(i remember looking at it few weeks before) So this is "that" hybrid where i send them my turbo and they upgrade the inside to Garrett stuff and then they send it back. It cost around 1200-1300 USD which is FAR cheaper than the HKS and it is what iam looking for(i just do not have experience like this...to send something off to "upgrade" ) @tylink720 that is like 150 USD turbo no? 😄 I dont think i have the "ease on my mind" with this kind of turbo. I just put over 7000k USD to "LINK" up my engine...dont want to blow it up with cheap turbo 😄     EDIT: https://www.cj-motor.com/gcg-turbo-charger-for-nissan-rb20det-rb25det-high?srsltid=AfmBOooVeOZ6CZ6r1AIv5m-KPaa6BvudIPJTY8LW78khkd-gQlsaCht9 I looked at this and it seems ok? It is that CGC hybrid and it costs around 1250 USD (with back shipping). Do any of you have experience with this hybrid on NEO turbo? I quickly look thru the forum/web and it seems very good.
    • Echo the awesome sentiment 👍 Definitely a car worth saving. Looking forward to seeing updates as well. 
    • Scenic roads, stunning skylines, and Chickos to finish it off! Join SAU NSW as we cruise through the Royal National Park and along Lawrence Hargrave Drive to Figtree! Sunday 26th October 2025 4:30PM Meeting Waterfall Station Parking 5:00PM Cruise Departure Royal National Park > Lawrence Hargrave Dr > Memorial Dr > Sid Parrish Park 6:15PM Arrival at Sid Parrish Park Figtree Meet Location: Waterfall Station Parking Final Destination: Sid Parrish Park RSVP: https://forms.gle/E4s5SiRKQfDdypky8 *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • It's funny, as Ive seen plenty of people use them in cheap builds on YT. And they actually go okay, even though a lot of other maxspeedingrods stuff is terrible. Those turbos seem reliable enough, the only part being, a good quality turbo that is "identical" to it, will out perform it day in and day out. In both a lower boost threshold, and the ability to flow more air at the same boost pressure. As a cheap cheap replacement, not a terrible choice. For cheap and shouldn't blow in a day, not terrible (like other eBay/Temu turbos) for low cost and still decent performance, that's where the question comes in to play from the results I've seen. I'd actually find it hilarious to buy one, and strap it to a paddock basher or some other cheap as POS originally NA car, and send it to the moon!
×
×
  • Create New...