Jump to content
SAU Community

Recommended Posts

Hi All

My name is Ron

Im new to this GTR thing and have a few questions to ask.

Firstly i have recently purchased a 93 R32 GTR and a PFC D-Jetro (thanks to Slide)

I was just wondering what would the costs be for -

1: to install and tune the PFC

2: to do a full service just to make sure everything is ok (as in change all fluids, belts, pumps?? )

and any other things that i should have looked at while its in the shop.

Any help is greatly appreciated

Thanks

Link to comment
https://www.sau.com.au/forums/topic/159601-service-costs/
Share on other sites

Hey Ron!

and welcome to SAU and SAUWA :P

i can only help with my question;

1: to install and tune the PFC

-im not sure about the cost of installing the PFC. But tuning should be between $400-$600 for your 1st tune.

Best to give some of the workshops around perth and call and they will be able to quote you up.

Check out the The Consolidated Workshop thread

http://www.skylinesaustralia.com/forums/in...howtopic=141454

for a list of workshops NOR and SOR.

My personal recommendation for NOR is Hyperdrive (for tuning/services etc)

Link to comment
https://www.sau.com.au/forums/topic/159601-service-costs/#findComment-2963186
Share on other sites

For a simple oil change in a workshop (eg XSpeed) you're looking at $180-$217 depending on the quality of oil used.

GT-R, go for the $217 one. They will also give you a report on what work may need to be done and the general overall condition of your car.

May sound like a lot, but it costs me $100 minimum to do my own oil changes, ~$90 for Mobil1 and $10 for a genuine Nissan Oil filter.

Link to comment
https://www.sau.com.au/forums/topic/159601-service-costs/#findComment-2963228
Share on other sites

im due for my big service now, going to in tune performance, located in bibra lakes SOR, getting timing belt changed, all fan belts changed, coolant replaced, oil replaced, safc dyno tuned, walbro fuel pump fitted. costing $800.

Link to comment
https://www.sau.com.au/forums/topic/159601-service-costs/#findComment-2963366
Share on other sites

im due for my big service now, going to in tune performance, located in bibra lakes SOR, getting timing belt changed, all fan belts changed, coolant replaced, oil replaced, safc dyno tuned, walbro fuel pump fitted. costing $800.

hey pal, where in bibra lake is that? i live there never seen it. Is the Walbro fuel pump included in that price or are they just puttin one you have in? i have also never seen your skyline around the area either :D

Link to comment
https://www.sau.com.au/forums/topic/159601-service-costs/#findComment-2964454
Share on other sites

Thanks for all the info guys.

I live south of the river in beckenham.

I was thinking about goin to Top Racing but havn't heard much about them.

Xspeed seems to be the most recommend workshop so i might pay them a visit

to see what im up for.

Link to comment
https://www.sau.com.au/forums/topic/159601-service-costs/#findComment-2965192
Share on other sites

Thanks for all the info guys.

I live south of the river in beckenham.

I was thinking about goin to Top Racing but havn't heard much about them.

Xspeed seems to be the most recommend workshop so i might pay them a visit

to see what im up for.

top racing provide good service and treat customers with respect unlike some other known shops.

plenty of people will recomend them on here

$217 oil change is a big big rip off, surely pulling a filter off and undoing a sump plug isnt worth $130, its about a 15-20 min job max. i suppose its good value if u got a 15L sump :P

Edited by CruiseLiner
Link to comment
https://www.sau.com.au/forums/topic/159601-service-costs/#findComment-2965726
Share on other sites

Top racing really know their work.

Every workshop has their pros and cons. But put it this way I'm yet to find a performance shop that stand behind their tune an ensure their work. The only other place I feel can do this would be Top racing after having dealt with 2 very well known performace shops when it comes to tuning the power FC D-Jettro, both their service and tune were very very poor indeed espically after "paying for what I got".

Rob

Edited by dan_the_man
Link to comment
https://www.sau.com.au/forums/topic/159601-service-costs/#findComment-2965816
Share on other sites

Thanks for all the info guys.

I live south of the river in beckenham.

I was thinking about goin to Top Racing but havn't heard much about them.

Xspeed seems to be the most recommend workshop so i might pay them a visit

to see what im up for.

give Top Racing a go

they arte the only workshop that touch my 93gtr

Link to comment
https://www.sau.com.au/forums/topic/159601-service-costs/#findComment-2966315
Share on other sites

Hi all again

I think i will go to Top Racing. I gave them a call and were really helpfull.

Just have to wait till i get PFC and then im booking it in.

I will ask about a leakdown test to see what condition the engine is in to.

Once again thanks for all of the advice and recommendations.

Link to comment
https://www.sau.com.au/forums/topic/159601-service-costs/#findComment-2968648
Share on other sites

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Im not entirely sure exactly what or where its leaking from, he started to pull the boots to swap to my new tie rods + ends and it just vomited fluid, so he closed em up up, swapped the rod ends to the old rods and let me know so I can figure a solution out, im guessing its all origional as as I passed 103k miles earlier this year im sure its just in need of a full overhual/rebuild anyways.    If i could just yank it off and be good it wouldn't be an issue to ship it out and wait for the turnaround but the guy I work with doesnt really have space to keep my car for a week or two at a time, would rather drop it off and have a replacement ready to drop in
    • What do you mean by "seals"? Internal hydraulic seals (ie, is it leaking PS fluid?) or the rack boots that close the rack onto the tie-rods? Because the former is a rebuild, and the latter is trivial that you or any nearby mechanic could do. Dunno about the cowl. Just buy what you think is required and get anything else you find/break afterwards. Wing? Dunno. Don't like R33s enough to pay attention to them. Mirror glass is just glass (on the surface that you want to polish). Go for it.
    • Hello! Long time lurker, been using the forums to address concerns and questions from afar for a while but I've struggled to find some answers so I guess its about time I made an account and formally asked some more knowledgeable people, since finding local skyline owners is hard (and shops that are knowledgeable or trustworthy to work on 'rare' cars are non existent out where im at, as skylines are quite uncommon to find in the wild around here). So the main 3 questions I have, 1: Steering rack has blown seals, well.. they kind of hold but they are not sealed properly anymore and as my R33 is my DD, i cant exactly rip the rack out and send it off or attempt to fix myself. As most refurb ones are around $1,100 or more shipped, and I have other things I need to work on around the car, I was seeking clarification on whether an S15 rack will more or less bolt right in, and whether a common mechanic could do any other required work to get it to fit. I ask, as I've found a supplier than can sell a manufactured as oem one for around 400, if not I'll likely order a used one from Jacks JDM, and take a risk on the seals there. The second question i have is that im replacing the front wiper cowl and have planned to buy 4 new clips and a new center clip but wasnt sure if there were any other clips that would also need to get replaced while I was at it. Given im sure any that are there now will simply break when I remove the old cowl... Last thing would be a fairly straight forward question, i think. If I manage (strong if, finding one has proven to be a pain) to find a R33 GTR spoiler/wing will it require much modification to bolt to a S2 R33 GTST? I've read the bolt patterns dont match but otherwise would bolt in, only options I have found with much luck is China stuff on ebay and carbonetics, which has a nice $650 shipping fee... so if anyone has any pointers where a US chap could locate one that would be great Random side question as well, the mirrors as I understand are mirror glass, and as im planning to polish my windows from water spots and surface scratches, i was hopeful cerium oxide would be fine for them too, as my research points to, but clarification is always nice. Any pointers would be appreciated, and while I have scoured the internet for answers if I missed a prior post somewhere that may answer these directly please point me towards it, as i must have simply missed it. I have seen a post here or there that has mentioned it, but I usually get 50-50 answers, or half answers... I dont have a lot of fab experience or mechanic experience, outside of hydraulic and pneumatic stuff I did in the military and with how hard it is to source stuff in the US, id rather not wing it and hemmoraghe money lol. Thanks guys! Sorry for the monumental first post haha
    • Yep, there's a very minor drift left that happens a few seconds after letting go of the steering wheel, but not enough to bother me. Enjoying the car still!
    • Got you mate. Check your email!
×
×
  • Create New...