Jump to content
SAU Community

Recommended Posts

Hi Guys,

I was given a complete brake setup from a R32 GTR yesterday (as he had upgraded) and he said it would be a good upgrade for my S1 R33. By the looks of it I can tell that the disks are obviously drilled compared to mine which are not but what are the other advantages? Should I also swap over the calipers? It all looks to be in good condition so pretty keen to see how it goes.

Any advice much appreciated.

Cheers

Andrew

Edited by harvesteros
Link to comment
https://www.sau.com.au/forums/topic/161740-brake-upgrade-advice-needed/
Share on other sites

Mate to my knowledge, all turboed R33's have R32 GTR brakes on the front, same calipers and rotors. And i think rears too. If the rotors are drilled then maybe they're the optioned brake packaged Brembos, in that case it would be an upgrade. If they are i'm not too sure of fitment but i think they're a bolt on swap.

If you intend to use the car on the track, i personally would not use drilled rotors, as they are prone to cracking when they get really hot.

Early model 32gtr calipers are the same as 33gtst. The later model 32gtr had Brembos, which are much better. So if the calipers have BREMBO, across the face, then fit them.

Slotted rotors are the best option

Cheers guys. I just had a look at my car and yes it appears that the calipers are the same, they are "SUMITOMO". I am not intending on using the car on the track, just road work so perhaps swapping to the drilled rotors would be a good option, what do you think? I have included a pic of the rotors (front and back), is it stock R32 gtr stuff?? Worth swapping it for my disks?

gallery_35735_1650_18581.jpg

Cheers again for all the advice

mate your 33 brakes are probably better

same size calipers

same diameter discs

gtr discs are 4mm thicker new (but i bet these arent new)

gtr discs are cross drilled and can crack

gtr calipers will be older and need a rebuild sooner

if you want an upgrade do it in this order:

new motul rbf600 brake fluid flushed through

new dba/rda discs

remove your brake backing plates

new brakes lines (braided or rubber as long as they are new)

master cylinder stopper

rebuild your calipers with new seals

or most importantly get better tyres if your brakes are fading

  • 9 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
×
×
  • Create New...